COMMAND SEQUENCES
You can set up your 6 in 1 IR/RF Remote Control to issue a set of up to 15 commands at the press of a key. Any sequence of commands you regu- larly perform can be reduced to a single key press.
Setting a Sequence
Here is an example of how to set up a sequence of commands that turns on your cable box and your TV and puts the TV on Channel 3, and how this sequence works when you press VIDEO SEQ.
Note: The 6 in 1 must be pointed at the device.
1.Hold down SET UP until the red light blinks twice, then release it.
2.Press 9 – 9 – 5. The red light blinks twice again. Then press VIDEO SEQ.
3.Press CBL – PWR – TV – PWR – TV – 0 – 3 – CBL.
Note: If your device requires the use of an ENTER key to select a channel, you must also use ENTER in your sequence.
4.To end the sequence, hold down SET UP until the red light blinks twice.
Whenever you press the selected sequence key, your 6 in 1 IR/RF Remote Control issues the se- quence of commands you entered.
Erasing a Sequence
1.Hold down SET UP until the red light blinks twice.
2.Press 9 – 9 – 5. The red light blinks twice. Press the sequence key you want to erase.
Need help? Call
15