Radio Shack 15-1925 If YOU have Problems, Manual Code Search, SET UP 9 9 1 PWR TV PWR TV PWR

15-1925.fm Page 20 Monday, July 19, 1999 12:59 PM

IF YOU HAVE PROBLEMS

MANUAL CODE SEARCH

If the 6 in 1 IR/RF Remote Control does not oper- ate your remote-controlled devices when you first set it up, you might have to find the correct code for your devices. You can try all the codes listed in the “Manufacturer’s Codes” section on Page 26 for the brand of your device, or you can follow these steps to search the 6 in 1 IR/RF Remote Control’s entire library.

1.Manually turn on the device you want to set up and press the corresponding device key on your 6 in 1 IR/RF Remote Control (TV, VCR, CBL, CD, and so on).

2.Aim the 6 in 1 IR/RF Remote Control at the device you want to operate.

3.Hold down SET UP until the red light blinks twice. Release SET UP and press 9 – 9 – 1. The red light blinks twice again.

4.Slowly alternate between PWR and the device key.

For example, if you are searching for a code to operate your TV, use the following sequence.

SET UP – 9 – 9 – 1 – PWR – TV – PWR – TV – PWR ...

Each time you press the TV key, the remote control advances to the next manufacturer’s code in the library.

5.When your device responds by turning off (or on, if it was off), immediately press SET UP to lock in the manufacturer’s code.

Note: Because of the large number of codes in the 6 in 1 IR/RF Remote Control’s library, this pro- cedure can take several minutes. If your device turns off during the search, but does not operate after you lock in the code, begin the search again, pausing longer between key presses.

Need help? Call 1-800-950-7044

20