Radio Shack 15-1925 owner manual Setting UP the 6 in 1’S RF Command Console, Lighting the Keys

15-1925.fm Page 8 Monday, July 19, 1999 12:59 PM

SETTING UP THE 6 IN 1’S RF COMMAND CONSOLE

After you install batteries in the 6 in 1, just plug the RF command console’s power cord into any stan- dard AC outlet in the same room as your IR re- mote-controlled devices (TV, VCR, cable box, and so on) and fully extended its antenna. Be sure the command console is pointed at the de- vices you want to control.

The command console has a 4-foot IR signal ex- tension cord for use with devices that are not in the command console’s line of sight. If you have such a component, plug the extension cord into the back of the command console and use the supplied double-sided tape to attach the exten- sion cord’s LED over or next to the device’s IR sensor.

Note: The 6 in 1 transmits both IR and RF signals at the same time. When testing the command console, be sure the 6 in 1 is not pointed at your devices.

LIGHTING THE KEYS

Press to light the keys on the remote. Now, every time you press a key, the 6 in 1 lights up and stays lit for about 5 seconds.

To turn off the light, press again.

Need help? Call 1-800-950-7044

8