SETTING UP YOUR REMOTE CONTROL
1.Refer to “Manufacturers’ Codes” on Page 26 and write down the codes for your original remote controls.
Note: Some manufacturers have several possible codes listed. Try each until you find the correct code. See “If You Have Prob- lems” on Page 20 if you need help.
2.Press the device key for the type of remote you are replacing (CD, VCR, CBL, TV, AUX1 or AUX2).
Hold down SET UP until the red light blinks twice, then release it. Enter the
For example, to replace a TV’s remote con- trol (manufacturer’s setup code 154), press:
TV – SET UP – 1– 5 – 4
3.When the red light blinks twice again, the 6 in 1 has accepted the code.
4.Point the 6 in 1 IR/RF Remote Control at your device and press PWR (or CH s for some cable boxes). Your device should turn off (or on, if it was off).
If the remote does not operate your device, try the other codes listed in the “Manufac- turer’s Codes” section for your brand of TV, VCR, cable converter, or other device.
Repeat Steps
Need help? Call
9