Marantz PV6111W manual Press To move Mark to Status, To set Status, To on to turn on the View

Page 44

Parent Control (VIEW TIMER) (Continued)

POWER DTV VCR/ DVD/

STB TV CATV

PERSONAL PREFERENCE

A B C D

ENTER

8	Press	or	to move the
	“ ” mark to “STATUS”.

:VIEW TIMER

VIEWING TIME 2H 00M

OFF TIME --H --M

STATUS OFF

	SELECT
	NEXT
	BACK
MENU	EXIT

VOL

CH

MENU

AV MODE

MUTE

INPUT

9	Press	ENTER	or	and then use
					:VIEW TIMER
		or		to set “STATUS”	STATUS
					OFF
					ON
	to “ON” to turn on the VIEW				SELECT
	TIMER.				MENU EXIT
					BACK

ANT-A/B

DISPLAY

ENT. FLASHBACK

10 Press

MENU

to exit.

• If you want to set “OFF TIME”, select “OFF TIME” in step 5.

TWIN

PICTURE Q-SOUND

	CH	VIEW
	CH	MODE
		MODE

INPUT		TITLE
REW		FF

CH/SKIP PAUSE STOP REC

VCR/DVD

DDFCPOWER

Note	Notice on Remaining VIEWING TIME
Note	• For every 30 minute interval, the remaining time will be displayed for four seconds.
	For the last five minutes, the remaining time will be displayed every minute.

•“0H 00M REMAIN” will be displayed for 10 seconds just before the VIEWING TIME is completed.

■To cancel the VIEW TIMER setting

1	Repeat steps 1 to 2 of “How to set VIEW TIMER” on page 43, then
1	“INPUT SECRET No.” appears.
2	Press and hold both ENTER and MENU on the front panel of the Rear
2	Projection TV simultaneously for about five seconds until the message
	“INPUT SECRET No.” disappears.

3	Press MENU to exit.
3	• The setting of the Secret No. is canceled and the STATUS of the

VIEW TIMER changes from ON to OFF.

•If you have forgotten your secret number, holding down ENTER and MENU on the front panel of the Rear Projection TV simultaneously for about five seconds causes the original secret number to be canceled. A new secret number can be entered after canceling the original secret number.

• When you enter the correct SECRET number, the VIEW TIMER mode is displayed.

Note If the secret number is incorrect, “SECRET No.IS INCORRECT” is displayed (for two seconds). Input the SECRET number again in this case.

•While the Rear Projection TV is OFF but the OFF TIME is set, pressing POWER cause “TIME OVER” to appear on the screen. If you do nothing, the Rear Projection TV will turn off in approximately 30 seconds.

44

Image 44

Contents Model PV6111W User Guide Contents Important Information Picture Burn Prevention Public Viewing of Copyrighted MaterialS2898A Main Features Supplied Accessories Before Operating Your Rear Projection TVBefore Operating Your Rear Projection TV Universal Remote Control Type of connectorAntenna Connections AntennasConnection with Converter/Descrambler Box without VCR Connection with Antenna Cable and VCR Connection with Antenna Cable Main Unit To open the coverBasic Remote Control Functions Infrared Transmitter Window PowerName of button Operation EZ Setup on First Power On Menu screen Press Menu to access MainMenu Functions Menu Summary TIMER/CLOCK You can adjust the screen size. See pages 31 ~Clock SET TIMER/CLOCK Sleep Time TV-ON Time Press To exitHow to set Closed Caption Closed CaptionCursor to CC Closed Caption Cursor to an item you want to setVideo Adjust Press Enter or To accessVideo mode Menu screen and then usePRO Adjust Mark to PRO ADJ. modeAccess the PRO ADJ. mode Then press Enter orTo set other PRO adjustments Video NROPC optical control Press or to select On or OFF, and then pressAudio Adjust Other Audio Settings AdjustMark to an item e.g Equisound you want toMTS/SAP Select mode To access the MTSCursor to MTS and then press ModeScreen Adjust Screen adjustment items vary depending on Screen size modePress or to adjust Vertical position, then press Cursor to ScreenParent Control V-CHIP operation Mpaa Rating ExampleExample 1.1 Age-Based setting Example 1.2 Age-Based settingExample 2.1 Content-Based setting Example 2.2 Content-Based settingCursor to Parent Ctrl How to Set V-CHIPParent Control First Setting Mpaa Rating Rating on TV RatingRepeat steps 1 to 4 of Mpaa Additional mode Repeat steps 3 to 5 for other settings you want to adjust OTHERS, then pressUse To move Cursor to an item e.g Canadian English you wantTurn on V-CHIP Block Repeat steps 1 to 4 of MpaaRating on Mark to StatusDisplayed Chip Block temporarily will be canceledPress Enter Input Secret No. will be Enter the 4-digit Secret No. by using Direct Access ~ V-CHIP select mode will be displayedRepeat the configuration of the V-CHIP Block on Repeat steps 1 to 2 of Mpaa Rating onParent Control View Timer View TimerPress To move Mark to Status To set StatusTo on to turn on the View If you want to set OFF TIME, select OFF Time in stepChannel Setup AIR/CABLE SettingCursor to CH Setup CH Setup modeCable Setting on CH Search modeSaving Broadcast TV channels to memory Channel Search Repeat steps 1 to 3 of AIRSetting on CH Memory modeRepeat steps 1 to 3 of AIR/CABLE Mark to CH MemoryFavorites mode FavoritesTo move Mark to the desired Position To input the channel number Into the memoryCable Setting on UNIV. Plus modeUniversal Plus Function Repeat steps 1 to 3 of AIRSetup Cursor to SetupSET UP mode Language modeGray Screen Cursor to onEnergy Save Convergence Adjust Energy Save setting onAccess the CONVER. ADJ. mode Repeat steps 1 and 2Then Use Move the blue cross to match it to Input Mode Access the Input ModePress Enter or Press To select Instrument HD/DVDCH/INPUT ID Press Mode Changing Screen SizeSelecting Ddfc Mode or AV Mode Selecting Ddfc ModeSelecting AV Mode 540PMulti-screen Function View two Screens Twin Picture ScreenPress Picture to make the left part Screen become larger To return to the initialFunction. By changing a full screen into Making Notes From the Program Content Freeze ScreenPress Freeze Freeze function serves as a memo Searching for a Program on a Different Channel Search Screen Press Search to display 3-SEARCH ScreenRight screens Twin picture displayPress Swap to interchange the left Using your Remote control with a DTV STB Decoder Using Your Remote With Your Rear Projection TVTo Identify Your VCR Direct Entry Method How to Identify a VCRTips on Identifying your VCR through the Search method VCR Brand Remote Control Code Number How to Identify a DVD Player While holding Press On your remote controlTo Identify Your DVD player -Direct Entry Method Press and the button lightsHow to Identify a DTV STB Digital TV Set-Top Box Identifying your DTV STB through the Search methodTo Identify Your DTV STB -Direct Entry Method Make sure STB lamp goes out and then release both buttonsTo Identify Your Cable Converter -Direct Entry Method How to Identify a Cable ConverterIdentifying your Cable Converter through the Search method Specifications Using the Video and Audio Input Jacks Connecting video equipment for video playbackVideo playback Using the Audio Output Jacks Before Calling for Service Quick Service Check List ProblemUnidad Principal Sección de control delanteraFunciones Básicas del Control Remoto Botones de selecció n del modo del control remotoProblema Antes de llamar al Servicio de ReparacionesCommandes avant Unité PrincipaleFonctions de Base de la Télécommande Capteur INFRA-ROUGEAvant de faire appel au Service Après-vente Liste DE Vérification Rapide ProblèmeDimensions for Installation Page Page Page Limited Warranty for the Marantz Rear Projection Television