Operation of the Remote Control for Other Devices
ENTER
| VCR/DVD |
| POWER |
VOL | CH |
MENU |
|
AV MODE | CH/SKIP |
MUTE |
|
REW
INPUT
VCR/DVD POWER
Press to turn the VCR/DVD player on and off.
VCR CHANNEL, DVD SKIP
CHANNEL UP ( ) / DOWN () for VCR, SKIP for DVD player
Press to scan up or down through channels on the VCR or SKIP for DVD player.
REWIND
Press to perform fast reversing with the tape/disc. | STOP | REW |
DISPLAY
ENT. FLASHBACK
TWIN
PICTURE SEARCH
VIEW
CH FREEZE SELECT MODE
INPUT | SWAP CM SKIP TITLE |
REW PLAY FF
CH/SKIP PAUSE STOP REC
VCR/DVD
DDFCPOWER
In Playback mode, hold the button down to view picture moving rapidly in reverse.
PLAY PLAY
Press to play back.
FF FAST FORWARD
Press to perform fast forwarding with the tape/disc. | STOP | FF |
direction.
PAUSE PAUSE
Press to temporarily stop the tape or disc during playback (or recording only for VCR).
Press again to restart playback.
STOP STOP
Press to stop the tape or disc.
REC RECORD
Press to begin recording only for VCR.
■Universal Remote Control
With the purchase of your Rear Projection TV you also have received the latest innovation in remote control technology. With its
Note | • Depending on the model, year produced, brand and type of VCR/DVD player, some models may not be compatible | |
with the remote control. | ENT. |
•Some brands of Cable TV converter Box may not enable channel selection until is pressed.
■Using your Remote control with a DTV STB (Decoder)
After installing the batteries, press DTV STB. (If you can change the channel of the DTV STB (Decoder) by
pressing or on the remote control, the unit is in the DTV mode.)
■Using Your Remote With Your Rear Projection TV
After installing the batteries, set the DTV
the channel of the TV by pressing or on the Remote Control, the unit is in the TV position.)
■“Identifying” Remote VCR/DVD player, Cable TV Converters and DTV STB
Your remote control has been set at the factory to operate your Rear Projection TV and many remote controlled VCRs, DVD players, Cable Converters and DTV STB. However, in some cases an easy
•In this
•Once “identified”, the remote sends the proper remote signals to operate your equipment.
•This identification step will not have to be repeated until power to the remote is interrupted, e.g. due to battery replacement.
■USING YOUR REMOTE CONTROL WITH A VCR OR DVD PLAYER
Once you make certain the remote control has “identified” your remote controlled VCR or DVD player, the remote control is ready to operate your equipment. The various VCR/DVD function buttons on the remote control will not operate your VCR/DVD player unless those features are available on the VCR/DVD player.
•All VCR/DVD buttons will operate whether the remote control is in the TV or CATV modes.
•For detailed information on the use of the VCR or DVD player, refer to the operation manual of the VCR or DVD player.
63