Using the Audio Output Jacks
These jacks are used for connecting a standard studio amplifier. Control of STEREO/MONO/SAP, BASS, TREBLE, BALANCE, VOLUME and MUTE is retained at the Rear Projection TV. These jacks relay the audio signals of all programs being displayed on the Rear Projection TV screen.
|
| R AUDIO L | VIDEO |
| MONITOR OUT |
| |
| (EXCEPT FOR HD AND |
| |
| COMPONENT SIGNALS) |
| |
|
| IN 1 | IN 3 |
|
|
| |
|
| IN 1 |
|
COMPONENT |
| ||
Y | PB | IN 3 |
|
PR |
| ||
IN 4 |
|
|
|
IN 5 |
|
|
|
CENTER IN |
| VAO R AUDIO L | VIDEO |
| R AUDIO L |
|
VAO AUDIO OUTPUT
or
AUDIO OUTPUT
To the audio input terminals
Stereo amplifier
Speaker System
(1)Before connecting the cable, turn on the Rear Projection TV and adjust the VOLUME control on the TV for a moderate listening level.
(2)Turn off the Rear Projection TV and connect the audio cord to the AUDIO OUTPUT or VAO AUDIO out JACKS on the Rear Projection TV.
(3)Turn the Rear Projection TV and stereo amplifier on.
(4)To change SPEAKER settings, see page 29. To check SPEAKER connections, see page 70.
(5)Adjust the VOLUME control on the stereo amplifier as desired.
(6)Control of the audio can be done using the audio controls (STEREO/MONO/SAP, VOLUME, EQUISOUND and MUTE), from either the remote control, or directly from the Rear Projection TV.
•For detailed information on the connection and use of auxiliary equipment, refer to the operation manuals of the equipment being used.
•When connecting monaural equipment to the AUDIO INPUT or OUTPUT of this set, use an audio connection cable and plug adapter as shown below.
•When using VAO terminals, for optimal sound quality, it is recommended to keep the Rear Projection TV’s audio output level high.
<Not supplied>
|
| Plug adapter |
To the Rear |
| To the equipment |
Projection TV |
| being connected |
Pin plug x2 | Pin plug | Pin jack / Mini plug |
72