KTI Networks KC-300D manual Applying Power, AC Power Adapter Specifications

Page 14

2.3 Applying Power

Before you begin the installation, check the AC voltage of your area. The AC power adapter which is used to supply the DC power for the unit should have the AC voltage matching the commercial power voltage in your area.

The AC Power Adapter Specifications

AC input power:	AC power voltage of your area, options -
	Rated AC120V/60Hz DC7.5V 1A
	Rated AC230V/50Hz DC7.5V 1A
	Rated AC100V/50-60Hz DC7.5V 1A
	Rated AC100V/50-60Hz DC5V 1A
	Rated AC240V/50Hz DC7.5V 1A

Steps to apply the power to the converters are:

1.Connect power adapter DC plug to the DC input jack located on the back of the converter before connecting to the AC outlet.

2.To ensure against accidental disconnection, tie the DC cable with the cable tie located the back of the converter.

3.Connect the power adapter to the AC outlet.

4.Check Power LED indication.

-14-

Image 14

Contents 10/100BASE-TX to 100BASE-FX Media Converters United States InternationalEthernet is a registered trademark of Xerox Corp Table of Contents Key Features IntroductionSpecifications Twisted-Pair Interface TPPortFiber Optic Interface FX Port User Accessible Settings SWOptionalSettingsUserinaccessibleJP1-JP3onboard Center Connector LEDIndicatorsDC Power Input Environmental Basic InformationMechanical CertificateSingle Fiber Bi-Di WDM Series Optical SpecificationsDuplex Fiber Series AutoMDI/MDI-XFunction Far End Fault FunctionSpecial Functions Auto-negotiation FunctionLink Fault Pass Through Function Mounting the Device InstallationUnpacking Applying Power AC Power Adapter SpecificationsNetwork Cables Configuration SetupMaking TP Port Connection Duplex Fiber Cwdm Series Duplex Fiber Series Model Connector WavelengthMaking FX Port Connection Model Link Fault Pass Through Function is enabled LED IndicatorsLink Fault Pass Through Function is disabled Optional Configuration Settings User Inaccessible JumpersForwarding Mode Setting JP1 JP1 Setting TP port to/from FX port ForwardmethodJP1-JP3 Factory Default Settings 2 802.3x Function Setting JP2FX Duplex Setting JP3