KTI Networks KC-300D manual Fiber Optic Interface FX Port, User Accessible Settings SW

Page 7

Fiber Optic Interface (FX Port)
Signal Compliance		IEEE 802.3u 100BASE-FX
Connector		SC, ST, MT-RJ, VF-45, LC or Single SC
Data Speed		100Mbps
Duplex Mode		Full-duplex and optional half duplex
Cable Types		Multimode (MMF) - 50/125, 62.5/125 ∝ m
		Singlemode(SMF)-9/125∝ m
Supported Link Distance		MMF up to 2km
		SMF up to 100km
		Single SMF WDM up to 40km
Eye Safety compliance		IEC825 Class 1
User Accessible Settings (SW)
NO.	SETTING	STATE	FUNCTION
SW1	TP Port Configuration	OFF	Auto-negotiation (default)
		ON	Forced mode
SW2	TPPortDuplex	OFF	Fullduplex(default)
		ON	Halfduplex
SW3	TP Port Speed	OFF	100Mbps (default)
		ON	10Mbps
SW4	Link Fault Pass Through OFF		Disable (default)
SW5	Reserved	ON	Enable
SW5	Reserved
OptionalSettings(UserinaccessibleJP1-JP3onboard)
NO.	SETTING	STATE	FUNCTION
JP1	Forwarding mode	Open	Store-and-forward (default)
		Short	Smart-forward mode
JP2	802.3x function	Open	Enable (default)
		Short	Disable
JP3	FX port duplex	Open	Full duplex mode (default)
		Short	Half duplex mode

-7-

Image 7

Contents 10/100BASE-TX to 100BASE-FX Media Converters International United StatesEthernet is a registered trademark of Xerox Corp Table of Contents Introduction Key FeaturesTwisted-Pair Interface TPPort SpecificationsOptionalSettingsUserinaccessibleJP1-JP3onboard User Accessible Settings SWFiber Optic Interface FX Port DC Power Input LEDIndicatorsCenter Connector Certificate Basic InformationMechanical EnvironmentalDuplex Fiber Series Optical SpecificationsSingle Fiber Bi-Di WDM Series Auto-negotiation Function Far End Fault FunctionSpecial Functions AutoMDI/MDI-XFunctionLink Fault Pass Through Function Unpacking InstallationMounting the Device AC Power Adapter Specifications Applying PowerMaking TP Port Connection Configuration SetupNetwork Cables Making FX Port Connection Duplex Fiber Series Model Connector WavelengthDuplex Fiber Cwdm Series Model Link Fault Pass Through Function is disabled LED IndicatorsLink Fault Pass Through Function is enabled User Inaccessible Jumpers Optional Configuration SettingsJP1 Setting TP port to/from FX port Forwardmethod Forwarding Mode Setting JP1FX Duplex Setting JP3 2 802.3x Function Setting JP2JP1-JP3 Factory Default Settings