KTI Networks KC-300D manual Making TP Port Connection, Network Cables, Configuration Setup

Page 15

2.4 Making TP Port Connection

TP port is featured to support connection to :

•Auto-negotiation devices

•Auto-negotiation incapable 10BASE-T devices

•Auto-negotiation incapable 100BASE-TX devices

Network Cables
10BASE-T:	2-pair UTP Cat. 3,4,5 , EIA/TIA- 568 100-ohm STP
100BASE-TX:	2-pair UTP Cat. 5, EIA/TIA-568 100-ohm STP
Link distance:	Up to 100 meters

Configuration Setup

To make a proper connection, the following configuration settings are recommended:

TP port link partner	SW1	SW2	SW3
Auto-negotiation device	Off: auto	Off: full duplex	Off: 100M
Fixed 10M half duplex device	On: forced	On: half duplex	On: 10M
Fixed 100M half duplex device On: forced		On: half duplex	Off: 100M
Fixed 10M full duplex device	On: forced	Off: full duplex	On: 10M
Fixed 100M full duplex device On: forced		Off: full duplex	Off: 100M

-15-

Image 15

Contents 10/100BASE-TX to 100BASE-FX Media Converters International United StatesEthernet is a registered trademark of Xerox Corp Table of Contents Introduction Key FeaturesTwisted-Pair Interface TPPort SpecificationsUser Accessible Settings SW OptionalSettingsUserinaccessibleJP1-JP3onboardFiber Optic Interface FX Port LEDIndicators DC Power InputCenter Connector Certificate Basic InformationMechanical EnvironmentalOptical Specifications Duplex Fiber SeriesSingle Fiber Bi-Di WDM Series Auto-negotiation Function Far End Fault FunctionSpecial Functions AutoMDI/MDI-XFunctionLink Fault Pass Through Function Installation UnpackingMounting the Device AC Power Adapter Specifications Applying PowerConfiguration Setup Making TP Port ConnectionNetwork Cables Duplex Fiber Series Model Connector Wavelength Making FX Port ConnectionDuplex Fiber Cwdm Series Model LED Indicators Link Fault Pass Through Function is disabledLink Fault Pass Through Function is enabled User Inaccessible Jumpers Optional Configuration SettingsJP1 Setting TP port to/from FX port Forwardmethod Forwarding Mode Setting JP12 802.3x Function Setting JP2 FX Duplex Setting JP3JP1-JP3 Factory Default Settings