KTI Networks KC-300D manual Introduction, Key Features

Page 5

1. Introduction

The 10/100BASE-TX to 100BASE-FX media converter series provides a media conversion allowing high-speed integration of fiber optic and twisted- pair segments. With 10BASE-T and 100BASE-TX support, the converters provide seamless translation between Ethernet and Fast Ethernet networks. A complete set of LEDs allows for quick status verification.

1.1 Key Features

The media converters also provide the following key features:

•Convert speed and media type

•Support full wire speed conversion

•Support 10Mbps and 100Mbps speed on TP connections

•Auto MDI/MDI-X detection function on the TP port

•Auto-negotiation function on the TP port

•Link fault pass through function

•Provide manual configuration settings for TP port to support connection to non-auto-negotiation devices

•Transparent to 802.1Q VLAN tagged packets

•Far End Fault function on FX port

•Support wide range of fiber options on the FX port

•Support media converter center chassis installation

•Support center chassis management

•Provide user-inaccessible settings for specific system applications

•Low power consumption

-5-

Page 4 Page 6
Image 5
Page 4 Page 6
Contents 10/100BASE-TX to 100BASE-FX Media Converters International United StatesEthernet is a registered trademark of Xerox Corp Table of Contents Introduction Key FeaturesTwisted-Pair Interface TPPort SpecificationsFiber Optic Interface FX Port User Accessible Settings SWOptionalSettingsUserinaccessibleJP1-JP3onboard Center Connector LEDIndicatorsDC Power Input Mechanical Basic InformationEnvironmental CertificateSingle Fiber Bi-Di WDM Series Optical SpecificationsDuplex Fiber Series Special Functions Far End Fault FunctionAutoMDI/MDI-XFunction Auto-negotiation FunctionLink Fault Pass Through Function Mounting the Device InstallationUnpacking AC Power Adapter Specifications Applying PowerNetwork Cables Configuration SetupMaking TP Port Connection Duplex Fiber Cwdm Series Duplex Fiber Series Model Connector WavelengthMaking FX Port Connection Model Link Fault Pass Through Function is enabled LED IndicatorsLink Fault Pass Through Function is disabled User Inaccessible Jumpers Optional Configuration SettingsJP1 Setting TP port to/from FX port Forwardmethod Forwarding Mode Setting JP1JP1-JP3 Factory Default Settings 2 802.3x Function Setting JP2FX Duplex Setting JP3
Top Page Image Contents