RCA P52731, P46732, P46738, P52730, P46731 manual Turn on TV, adjust the volume, and select a channel

4.Connect antenna or cable-TV system.

Most antenna or cable-TV systems can be connected as show here.

•Details for connecting a home antenna to your TV are on page 30.

•Details for connecting a cable-TV system to your TV are on pages 31.

•Details for connecting a VCR to your TV are on pages 35-36.

!3. Attach power cord.

First attach the fiat end of the power cord completely into the connector on the back of your TV, and then plug the other end into a wall outlet.

i L_ -_SS

Incoming Cable from Antenna or Cable-TV System

6.Turn on TV, adjust the volume, and select a channel.

•Press the TVbutton on the remote to turn on the TV. When using the remote, remember to point it at the front of the TV.

•Press the VOL up or down button to adjust the volume to a desired .level.

•Press the CHAN up or down button to select a channel in memory. You can also press two number buttons to select a channel. To select a 3-digit cable channel (up to channel 128), press and hold number button 1 until 1-- appears on the screen• Then press the other two numbers. Channels 2-13 were programmed into the channel memory for you at the factory, so pressing CHAN up or down stops at these channels only. When you start the AutoProgramming feature (described below), your set automatically scans through all channels and place only the active channels for your area into its channel memory.

o

•Details about using the remote are on page 8-11.

7.Converge Colors if Necessary.

If you notice colored rings or halos around objects in the picture, you may need to converge the colors. Over a period of time, the picture tubes can drift out of alignment due to normal bumps and vibrations or moving the TV. Details for converging the colors are on page 15.

3