
Can'tselectcertainchannel
Noisystereoreception
No picture, no sound but power light is on
Sound okay, picture poor
Picture okay, sound poor
No stereo on known stereo Station
Can't get two channels in
No picture while Using
Small picture does not have color.
Remote no longer controls cable box, VCR or audio equipment
•Channel may not be in Channel Memory. Try pressing number buttons.
•If using VCR, check to make sure TV/VCR switch on VCR is in correct position.
•To select cable channels 100 thru 128, press number button 1 until
•Channel may be
•May be a weak station. Change STEREO/SAP function to MONO setting instead of STEREO.
•Maybe someone changed CABLE/AIR function to wrong position.
•Maybe a vacant channel is tuned.
•For Channels 90,91, and 92, make sure the component connected to those INPUT jacks is turned on in order to see the picture.
•If watching VCR (connected only through antenna input), make sure TV is tuned to channel 3 or
make sure TV/VCR switch on VCR is in correct position.
i
! • Check antenna connections.
I • Try adjusting SHARPNESS function to improve weak signals.
* Try another channel.
•Try adjusting VOLUME, BASS, and TREBLE controls.
•If station is sending stereo, try changing STEREO/SAP function to MONO setting for clearer sound.
Try adjusting SRS (O) controls to turn SRS (O) off or on.
•Make sure STEREO/SAP function is in STEREO mode.
•If using the VCR1 or VCR2*LD button, make sure it is programmed to select the proper video input channel as described on page 26.
If Using an
If usrag a VCR, make sure the AUDIO and VIDEO OUT jacks on the VCR are connected to the TV's AUDIO and VIDEO IN jacks.
If you have an
The small picture will not have color if the large picture signal does not have
the color burst reference. All color signals and some
are sent with color burst information. Try changing channels of the large picture.
•Try not to press any buttons on the remote while changing its batteries. You may have to reprogram the proper code into the remote.
49