Basic Operations | 08 |
Turning off the power
1Press TV a on the remote control unit or STANDBY/ON on the Plasma Display.
•The system enters the standby mode and the image on the screen disappears.
•Both STANDBY indicators light up red.
•It is recommended to place the system into the standby mode by pressing TV a on the remote control unit. This allows the system to automatically receive Electronic Program Guide information signals in the standby mode.
2Press POWER on the Media Receiver.
•The STANDBY indicator on the Media Receiver turns off and the one on the Plasma Display flashes red.
3Press POWER on the Plasma Display.
•The STANDBY indicator on the Plasma Display turns off.
•You can also reverse steps 2 and 3.
•If you are not going to use this system for a long period of time, be sure to remove the power cord from the power outlet.
English
Plasma Display/Media Receiver status indicators
| Indicator | Status |
| System Status |
Plasma Display | Media Receiver |
| ||
|
|
|
|
|
POWER ON | STANDBY | POWER ON | STANDBY |
|
|
|
|
|
|
|
|
|
| Power to the Plasma Display and Media Receiver is off. Or the power |
|
|
|
| cords have been disconnected. |
|
|
|
|
|
|
|
|
| Power to the system is on. |
|
|
|
|
|
|
|
|
| The system is in the standby mode. |
|
|
|
|
|
|
|
|
| Power to the Media Receiver is off. Or the power cord has been discon- |
| Flashing |
|
| nected from the Media Receiver. |
|
|
|
| |
|
|
|
|
|
|
|
|
| Power to the Plasma Display is off. Or the power cord has been discon- |
|
|
| Flashing | nected from the Plasma Display. |
|
|
|
|
|
For other than the above, see “Troubleshooting” on page 106.
29
En
29 | 7/24/03, 1:58 PM |