Electronic Program Guide (EPG) (for DTV Only)
Recording TV programs via a VCR | 4 Press / to select “ANALOG”, and then press | |
controller | ENTER. | |
If you connect an appropriate VCR controller to the | • A dialog box for confirmation appears. | |
Media Receiver, you can preset digital TV programs for |
|
|
recording with a connected VCR. See page 78. |
|
|
|
| |
1 Press DTV GUIDE. |
|
|
• The EPG screen appears. |
|
|
2 Press / and / to select a program to be |
|
|
preset, and then press ENTER. |
|
|
• A setup menu appears. |
|
|
|
|
|
10
English
3Press 
/
to select “Program Rec”, and then press ENTER.
• A dialog box for mode selection appears.
5Press 
/
to select “OK”, and then press ENTER.
•The program is preset and the schedule table is restored.
•A red square icon appears for the preset program.
•A black icon appears for overlapped presetttings.
6Press DTV GUIDE to exit the Program Guide.
•Switch on the recording equipment at least 30 seconds before the start of the preset program; otherwise recording will not be executed.
•Finish presetting operations two minutes before the start of the program; otherwise presettings may fail.
•For priorities about overlapped presettings, see “Priority rules for overlapped presettings” on page 63.
•Confirm that the video output terminals on the Media Receiver have been connected to the signal input terminals on the VCR to be used for recording.
•If you switch off the system using the POWER button, the program presetting will become ineffective. Be careful not to switch off the power.
61
En
61 | 7/24/03, 2:00 PM |