13Useful Features
Using the learning function
1Slide the Mode switch to match the device whose remote control signal you want to be learned.
2Press EDIT/LEARN and 2 at the same time. •The LED flashes.
3Press a button to be learned.
•The LED lights up.
•For the functions that can be learned, see pages 100 to 105.
•When learning is finished, the LED starts flashing again.
4Press EDIT/LEARN again to exit the Learn mode.
•To exit the Learn mode halfway, press EDIT/LEARN again.
•If the Mode switch selection is changed when in the Learn mode, the Learn mode is cancelled.
•If no operation is performed for more than one minute, the Learn mode is cancelled.
•It takes about 2 seconds to finish code transmission. Do not interrupt it halfway. Wait until the LED flashes again.
•You can reset all learned codes to the factory de-
faults. When not in the Learn mode, press and hold TVa, and then press D and k at the same time.
98
En
98 | 7/24/03, 2:01 PM |