Panasonic WJ-ND400 manual Setting the IP Address, Setting and Canceling Key Lock

ND400_Basic.book 43 ページ ２００８年４月８日 火曜日 午後３時５９分

Using the Front Panel for Operations

Setting the IP Address

Settable items are the same as those in "Checking the IP Address (page 42)".

Configure the settings for each item by switching between screens using the following operations. When the cursor is ">", use the arrow buttons (up or down) to switch between screens. The cursor is shown with an under bar (_).

The ports are displayed as follows: Camera port: PT #1, Client PC port: PT #2, and Maintenance port: PT #3.

Use the arrow buttons (left or right) to switch between ports.

Gateway and HTTP port settings are configured under the client PC port (PT #2).

The LCD changes as follows when using the arrow buttons (up or down).

[SET]

[ESC]

Important:

•Always configure the network settings for the ports using different subnet masks. Using the same subnet mask may result in improper network communication.

Configuring the Settings for Each Item

1 Click the [SET] button when the cursor is [>].

The cursor moves to the number area.

•When the cursor is ">" and you press the arrow buttons (left or right), the PT #2 and PT #3 screens are displayed and you can select other ports.

2

3

Move the cursor using the arrow buttons (up or down) and enter values using (up or down).

Press the [ESC] button to move the cursor to ">" and check the settings.

Setting and Canceling Key Lock

You can lock the buttons on the front panel to prevent them from being operated. Press the [SET] button on the Key Lock Setting screen to lock the keys. [Keylock Enabled] is displayed. Then, it returns to the display format screen.

[SET]

To cancel the key lock, enter the password (default: 12345) on the Password Entry screen. You can change the password on the settings menu. Refer to the Setup Instructions (PDF file) for more information.

43