Instruction of the installation
Assembling the wall stand
1 Check the strength of the installation location.
The height measurements marked ** are particularly important. Do not attempt to set up the pedestal in a location where these dimensions and a clearance of at least 100 mm at the top of the display unit should be provided.
1)On the wall, measure and mark a height 650 mm above the floor;
2)Measure and mark the location 475 mm horizontally to the right of the mark you made in 1). Measure and mark points 180 mm and 360 mm above each mark (for a total of six marked locations);
3)Drill a hole at each of the six marked locations on the wall.
Units : mm
744(2919/64)
560(22 1/16)
390(1523/64)
/32) |
|
3 |
|
(7 | (15 |
180 | |
| 4)/ |
| 3 |
(7 | 400 |
32)/ |
|
3 |
|
180 |
|
/8) |
| ) | |
7 |
|
| 16 |
631.5(24 |
| / | |
| 1 | ||
Wall installation holes | (24 | ||
** | � | (4 locations) | 611.5 |
|
|
| |
|
| Spare wall installation holes | ** |
|
| (2 locations) |
|
|
| Floor surface |
|
Refer to the holding b ra cke t i n s t a l l a t i o n measurements in the drawing left. Ensure that the wall is able to bear the weight at each of the 4 u p p e r a n d l ow e r installation locations.
Add reinforcement if any of these locations are not strong enough.
Ensure an area of at least 650 mm by 1,230 mm in length at the location where you plan to install the holding bracket.
The holding bracket has 6 slits through which the bracket can be fixed to a wall with screws.
If the wall material does not allow sufficient strength by using six installation holes, use some of the spare holes. However, depending on the construction material used at the place of installation, cracks may develop if the screws are inserted too close to each other.