2 Fix a M6 screw, through any of the slits in the bracket, into the corresponding hole in the wall.
Using a level along the top or bottom edge, ensure that holding bracket is horizontal.
The holding bracket must always be installed. It prevents the display unit from falling after installation.
3 | Fix the screws through the slits into the remaining three holes. |
4 | Provisionally tighten the fixing screws. |
Fixing the insulating spacers to the display unit
1 | 1) | Spread a clean cloth over a level floor or base, and place it on the |
| display unit face down. | |
| 2) | Remove the screws and covers. |
|
| Keep them in a safe place for possible future use. |
If the screws protrude more than 5 mm, it will n o t b e p o s s i bl e t o proper ly install the display unit.
Carefully place the Wide Plasma Display face down on top of a clean cloth, which has been s p r e a d o ve r a f l a t surface with no other objects on it, and then proceed to the next step.