PROGRAMMING THE REMOTE CONTROL
Programming the Remote Control
The Universal Remote Control can be programmed to operate many manufacturers’ components using the component function buttons for TV, VCR, DVD. Follow the procedures for programming your Remote Control with and without codes for the component. Determine the manufacturer of the component and look in the table for the code.
Programming With Code
•Confirm that the external component is plugged in and is turned on.
•Turn the component off.
•Press the ACTION and POWER button, together, for at least 5 seconds and then let go of the buttons.
•Press appropriate component button (TV, VCR, DVD) on the Remote Control.
•Enter the
•Press the Remote Control POWER button to test the component. If the procedure was successful, the component will turn on.
Unsuccessful Code
If the component does not operate with the Remote Control, repeat the procedure using another code. (Some brands have multiple codes.)
If an incorrect code is entered, or if the procedure takes longer than 30 seconds, the programming will fail.
Programming Without Code
This procedure searches all codes and is called the “sequence method”.
•Confirm that the external component is plugged in and is turned on.
•Turn the component off.
•Press the ACTION and POWER button, together, for at least 5 seconds, and then let go of the buttons.
•Press appropriate component button on the Remote Control.
•Press the button to move forward to the next code. Press the button to move backward.
•Press the Remote Control POWER button to test the component. If the
procedure was successful, the component will turn on.
Note: Repeat the preceding two steps until the component code is found. It may take many attempts before the correct code is found.
• After the code is found, press the ACTION button to store the code.
26