Panasonic CQ-D1703N manual Observe the following cautions when using this unit

Page 3

Caution

Observe the following cautions when using this unit.

Keep the sound volume at an appropriate level.

Keep the volume level low enough to be aware of road and traffic conditions while driving.

This unit is designed for use exclusively in automobiles.

Do not operate the unit for a prolonged period with the engine turned off.

Operating the audio system for a long period of time with the engine turned off will drain the battery.

Do not expose the unit to direct sunlight or exces- sive heat.

Otherwise these will raise the interior temperature of the unit, and it may lead to smoke, fire, or other damage to the unit.

Do not use the product where it is exposed to water, moisture, or dust.

Exposure of the unit to water, moisture, or dust may lead to smoke, fire, or other damage to the unit. Make especially sure that the unit does not get wet in car washes or on rainy days.

Set the volume level to low enough before the AUX connection is completed.

Failure to observe this, the loud noise may come out and damage your speakers and your hearing. Direct connection of the speaker/headphone output of an external device with- out any attenuator may distort sound or damage the con- nected external device.

Observe the following cautions when installing.

Refer wiring and installation to qualified service personnel.

Installation of this unit requires special skills and experience. For maximum safety, have it installed by your dealer. Panasonic is not liable for any problems resulting from your own installation of the unit.

Follow the instructions to install and wire the product.

Not following the instructions to properly install and wire the product could cause an accident or fire.

Take care not to damage the leads.

When wiring, take care not to damage the leads. Prevent them from getting caught in the vehicle chassis, screws, and moving parts such as seat rails. Do not scratch, pull, bend or twist the leads. Do not run them near heat sources or place heavy objects on them. If leads must be run over sharp metal edges, protect the leads by winding them with vinyl tape or similar protection.

Use the designated parts and tools for installation.

Use the supplied or designated parts and appropriate tools to install the product. The use of parts other than those supplied or designated may result in internal damage to the unit. Faulty installation may lead to an accident, a malfunction or fire.

Do not block the air vent or the cooling plate of the unit.

Blocking these parts will cause the interior of the unit to overheat and will result in fire or other damage.

Do not install the product where it is exposed to strong vibrations or is unstable.

Avoid slanted or strongly curved surfaces for installation. If the installation is not stable, the unit may fall down while driving and this can lead to an accident or injury.

Installation Angle

The product should be installed in a horizontal position with the front end up at a convenient angle, but not more than 30˚. The user should bear in mind that in some areas there may be restrictions on how and where this unit can be installed. Consult your dealer for further details.

Wear gloves for safety. Make sure that wiring is completed before installation.

To prevent damage to the unit, do not connect the power connector until the whole wiring is completed.

Do not connect more than one speaker to one set of speaker leads. (except for connecting to a tweeter)

Observe the following cautions when handling the battery for the remote control unit.

Use only specified battery (CR2025).

Match the polarity of the battery with the (+) and (–) marks in the battery case.

Replace dead battery as soon as possible.

Remove the battery from the remote control unit when not using it for an extended period of time.

Insulate the battery (by placing them in a plastic bag or cov- ering them with vinyl tape) before disposal or storage.

Dispose of the battery according to the local regulations.

Do not disassemble, recharge, heat or short the battery. Do not throw a battery into a fire or water.

In case of battery leakage

Thoroughly wipe the battery liquid off the battery case and insert new battery.

If any part of your body or clothing comes into contact with battery liquid, wash it with plenty of water.

If battery liquid comes into contact with your eyes, wash them with plenty of water and get immediate medical attention.

E N G L I S H

2

Warning

For your safety, this system is designed not to see the moving pic- ture while you are driving.

When connecting this unit to the front monitor (on-dash/in-dash):

¡Park your car in a safe place and use the parking brake lever before seeing the moving picture.

¡For your safety, you must ensure that the connection of the parking brake lead is correct. (a Page 51)

Warning

When driving please enjoy sound only.

3

CQ-D1703N

Image 3
Contents Model CQ-D1703N Safety Information Observe the following warnings when using this unitObserve the following warnings when installing Observe the following cautions when installing Observe the following cautions when using this unitClass 1 Laser Product Laser Radiation When Open Do not Stare Into BeamThis symbol is only valid in the European Union Laser ProductAccessories Contents FeaturesEd. Otherwise, pictures appear incorrectly. Default External Power Amplifier CY-PA2003, etcColor LCD Display CY-VM7203N Discs that can be Played Back Disc DVDCD-R/RW Preparation Remote Control UnitTV Type setting ACC SettingMute PowerVolume General Main Unit24-hour system is used for the clock SourceAUX1 AUX2General General Remote Control UnitDiscs DVD/VCD/CD/MP3/DivX Band Radio ModeTuning RadioManual Preset Memory Station PresetPreset Station Calling Auto Preset Memory APMRDS Basics Radio Data System RDSDisp Display TA/AF Alternative Frequency Preset Station Calling Best Station ResearchAlternative Frequency AF Display ChangeTraffic Announcement TA VolumePTY Preset Programme Type PTY ReceptionPTY Selection PTY Preset Default Preset No Programme TypeOther PTY functions Enhanced Other Network EON Other RDS functionsDisc Eject Only for remote control unitBefore Disc Playback OSD On-Screen DisplayCD Player MP3/DivX Player Folder SelectionFile Selection Direct Folder Selection Folder Random PlayDirect Selection Folder Repeat PlayDVD display example When a disc is in the playerDVD/VCD Player 3DVD disc 3VCD discFrame to Frame Play DVD VCD Functions Only by Remote Control UnitDisc Menu DVD Title Menu DVDPress Menu w Press About DivX VOD contentOnly for remote control unit, a Page 42 User Settings Display the unit’s registration codeRange Compression DVD Subtitle DVD DivXAudio VCD Angle DVDOSD On-Screen Display Track play time Total play timeID3 TAG on 3VCD Video CD Text off Play time 3013DVD DVD Video Text off Chapter play time Total play timeCommon Points to remember when making MP3/DivX filesDisplayed items Displayable charactersCopyright No warrantySupported file systems Maximum number of files/foldersAudio Output Level for P-MODE Audio SettingsBass/Treble Balance/FaderUp w Down Regular modeTurn Volume 341PTY Language Selection RDS Mode Function SettingsLocal Tuning Radio mode Region REG Mode FM mode361 CQ-D1703N External Mute Private Mode P-MODETurn VOLUME. Press or on the remote control unit Press Volume Push SEL selectACC on No sound Default Steps decrease UnchangedHas ACC position Set to OFF if your car has no ACC positionUser Settings English Chinese Finish the settingExample 1. English English French Spanish Chinese German Italian OtherOn-Screen Messages Select each setting menuTV Type TV DisplaySelect each item Finish the setting TV Display ModeNtsc Code Language Name Language Code ListDefinition of Terms Remove the Face Plate Install the Face PlateFuse MaintenanceHow to hold a disc Disc cleaningHow to install the unit InstallationY and u consist of a set. YEP0FZ5725 Consult a professional for installationSide to side Horizontal Front to rear YEFX0217263AWiring Before WiringSpeaker Connection When connecting this unit to the rear monitor Clip Connector u Car chassisHand brake ISO Antenna Adapter eAntenna To ACC power, +12 V DC Optical Digital Output ConnectorExternal Remote Control Lead Brown/black stripe Power Lead ACC or IGN RedRear Monitor for P-MODE 2ch External Power Amplifier CY-PA2003 option¡ Setting P-MODE to on zeros the output of PRE-OUT REAR. a Another ConnectionFinal Installation Final CheckLead Connections Troubleshooting Preset stations cannot be stored Problem Possible cause a Possible solutionOnly strong signal sta- tions can be received Number of auto preset stations is less thanIndicator lights Was already set upWhen selecting PTY AF stations. Update of the AF list ended in failurePossible cause a Possible solution Disc unejectable Tors Video signal setting of the connected monitorUser settings is not Through a menu screen Used Ejected Disc has unplayable formatted dataDisplay Display Possible cause a Possible solutionCD/MP3/DivX DivX VOD displayed on connected monitorSales and Support Information Customer Care CentreFor UK and Ireland customers only Specifications Web Site http//panasonic.net YEFM285852A NT0506-1066
Related manuals
Manual 64 pages 42.57 Kb