Location and function of each part
Projector <Top, right and front> |
| ||
$ | # |
| 0 |
% |
| % |
|
& |
|
|
|
' |
|
|
|
( |
|
| |
) |
|
| |
|
| ' | , |
* | & |
| |
+ |
|
| |
Projector <Back and bottom> |
| ||
# ' | & | % | Preparation |
|
|
| |
$ |
|
|
|
#Remote control signal receptor |
| WARNING |
|
(page 20)
Do not bring your hands or other
#Projector control panel (page 14)
$Focus ring (pages 29 and 48)
%Air inlet ports
Do not cover these ports.
&Leg adjuster buttons(L/R) (page 28)
These buttons are used to unlock the front adjustable legs. Press to adjust the angle of tilt of the projector.
'Front adjustable legs(L/R) (page 28)
(Lens release button (page 49)
This button is used when using a projection lens that is sold separately.
)Projection lens
*Lens cover
+Remote control signal receptor (page 20)
,Air filter (page 62)
-Connector panel (page 16)
.Power input socket (AC IN) (page 28)
The accessory mains lead is connected here.
Do not use any mains lead other than the accessory mains lead.
/MAIN POWER switch (pages 28 and 29)
0Speaker
$Security lock
This can be used to connect a
2855 Campus Drive
San Mateo, CA 94403 USA Tel
Fax
NOTE:
BInformation given above may be changed in future.
%Carrying handle
&Lamp unit holder (page 63)
'Air outlet port
Do not cover this port.
objects close to the air outlet port.
BHeated air comes out of the air outlet port. Do not bring your hands or face, or objects which cannot withstand heat close to this port, otherwise burns or damage could result.
NOTE:
BDuring projection of an image, the cooling fan will operate, emitting a small noise as it operates. Turning the lamp on or off will cause this noise to increase a little.
BBy using the OPTION menu to set “LAMP POWER” to “LOW”, the operating sound of the fan can be reduced. (Refer to page 45.)