Esoteric owner manual For U.S.A, UX-1 Pi UX-3 Pi, Optical pickup

Page 3

WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION

<DO NOT REMOVE THE EXTERNAL CASES OR CABINETS TO EXPOSE THE ELECTRONICS. NO USER SERVICEABLE PARTS ARE WITHIN!

<IF YOU ARE EXPERIENCING PROBLEMS WITH THIS PRODUCT, CONTACT TEAC FOR A SERVICE REFERRAL. DO NOT USE THE PRODUCT UNTIL IT HAS BEEN REPAIRED.

<USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

This product has been designed and manufactured according to FDA regulations “title 21, CFR, chapter 1, subchapter J, based on the Radiation Control for Health and Safety Act of 1968“, and is classified as class 1 laser product. There is not hazardous invisible laser radiation during operation because invisible laser radiation emitted inside of this product is completely confined in the protective housings.

The label required in this regulation is shown .

For U.S.A.

For U.S.A.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following

UX-1 Pi

UX-3 Pi

ENGLISH

measures:

Reorient or relocate the equipment and/or the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

CAUTION

Changes or modifications to this equipments not expressly approved by TEAC CORPORATION for compliance will void the user’s warranty.

Optical pickup

 

Type

: SLD6163RL-G

Manufacturer : SONY CORPORATION

Laser output

: Less than 1mW on the objective lens

Wavelength

: 785±15 nm (CD), 655±10 nm (DVD)

 

 

3

Image 3
Contents UX-1 Pi/UX-3 Pi Important Safety Instructions For U.S.A UX-1 Pi UX-3 PiOptical pickup Contents Read this before operation Before UseWhat’s in the box Conventions about This ManualChanging the Color System NTSC/PAL Placement of the unitMaintenance Beware of condensationFor European customers Disposal of your old appliance Restoring factory settingsType of discs that can be played on this system DiscsExample of Icons used on DVD discs Following discs cannot be played with this unitComponent Video Connection to a TVB P R Component Video Hdmi D1/D2Video output terminal Hdmi video/audio output terminalD1/D2 video output terminals component Component video output terminalsConnection to an amplifier etc AudioDigital in Digital in Optical Coaxial Link Audio terminal Digital audio output terminalsAnalog audio output terminals RS-232C Word sync connectorSignal GND connection Power cord receptacleFront panel features Understanding the remote control unit How to insert the batteries Front panel display Insert the disc label side up Press the Power button to turn the unit onPlayback Press the OPEN/CLOSE button L to open the trayOn-screen menu Opening and closing the tray Pausing playback freezing the pictureResume mode Stopping playbackSelecting a chapter or track Selecting groups and titlesSkipping playback Selecting the playback areaTitle, group, disc repeat Repeat modeFast scanning Chapter and track repeatSelecting audio Selecting subtitlesUse the Subtitle button to select DVD subtitles DIMMER1 Changing camera angleDimming subtitles Dimmer OFFFrame advance Slow motion/frame advanceLip sync Slow motionTurning video on and off Display dimmingOFF DVD video stopped, on-screen display Changing the display modeDVD video playback main unit display DVD video playback on-screen displaySuper Audio CD/CD/video CD playback on-screen display DVD audio playback on-screen displayDVD audio stopped, on-screen display Super Audio CD/CD/video CD playback main unit displayHrgb Hcol Hfrc Down Setting Digital Filter, HDMI, 4% down, Word Sync and i.LINKHdmi Hdmi video output format ADF Digital FilterHasp Hdmi aspect ratio Hexp Hdmi expandHfrc Hdmi Frame Rate Converter Word Word sync LinkPCM Use the cursor buttons to navigate the menus Settings introductionFactory settings are marked with an asterisk Exit the setup mode by pressing Setup once moreCD Digital Direct Settings AudioAnalog output settings Digital output settingsGroup playback mode DVD audio Audio DRC Dynamic Range ControlDownmix Settings Video Video adjustmentEnter Audio language selection Settings LanguageProgressive scan setting DCDiSubtitle language selection Displaying subtitlesOn-screen display language Language Code Language Code ListSpeaker Size Use these speaker setup menus in the following cases onlySpeaker levels General q Speaker Setting q DistanceGeneral q Speaker Setting q Level Speaker distanceDTS Settings GeneralTest tone length Digital output formatsSettings General/Video Out TV screenVideo output Closed captioning Still modeComponent video output PAL-NTSC conversionParental Control Settings General/DisplayPlaying a controlled disc Setting the level of controlResetting the password Country CodeTroubleshooting GeneralAudio Word Sync VideoData transfer rate How to connect multiple i.LINK-capable devicesLink IEEE1394 Copyright protection system Dtcp