Esoteric UX-1 Pi Word sync connector, Signal GND connection, Power cord receptacle, RS-232C

Connection to an amplifier etc. (2)

I

BNC coaxial cable

WORD SYNC OUT

Master clock generator (G-0s, AZ-1, etc.)

L

K

Supplied power cord

Wall socket

J

IWord sync connector

This allows the use of an externally-generated word clock connection, using a commercially available BNC coaxial cable.

Devices producing such a suitable clock signal include external D-A converters or dedicated word clock generators. Connect the SYNC OUT (or WORD OUT) of such a device to the unit.

When using the WORD SYNC connector, set “WORD” to “ON” (see page 33).

JSIGNAL GND connection

Use a commercially available PVC-covered cord to connect the signal ground terminal on the unit to the amplifier signal ground.

<Note that this is NOT an electrical safety ground (earth).

KPower cord receptacle

After all other connections have been made, insert the supplied AC power cord into this receptacle, then connect the other end of the power cord into the wall socket.

<Ensure that your AC voltage corresponds to the voltage marked on the rear panel of the unit. Consult a qualified electrician if you are in doubt.

<Use only the supplied Esoteric power cord. Use of other power cords may result in fire or electric shock. Unplug the power cord when you are not going to use the unit for an extended period of time.

LRS-232C

Control terminal for use by custom installers.

14