Symphonic WF803 owner manual Special Features, Copying a Video Tape, To Monitor the Recording

SPECIAL FEATURES

COPYING A VIDEO TAPE

VCR

You can make copies of video tapes made by friends or relatives for your enjoyment.

You can not copy a DVD to a videotape.

Warning:

Unauthorized recordings of copyrighted video tapes may be an infringement of copyright laws.

Connect the recording VCR (this unit), the playing VCR (another source) and your TV using the follow- ing diagram.

¡You can use the AUDIO/VIDEO input jacks on the front panel of the DVD/VCR instead of using the jacks on the back.

[Recording VCR]

(this unit)

DVD/VCR	VCR	DVD
AUDIO OUT		S-VIDEO COMPONENT	AUDIO	DIGITAL
		OUT VIDEO OUT	OUT	AUDIO OUT
ANT-IN
L		Y
R	IN	Cb	L
ANT-OUTVIDEO OUT				COAXIAL
	VIDEO IN	Cr	R

RF cable
(supplied)	Audio/Video cables
[TV set]	(not supplied)
(Use for monitoring)
	OUT IN
	AUDIO
	VIDEO
ANT in	[Playing VCR]
	(another source)

TO MONITOR THE RECORDING

1Turn on the TV and set the TV to channel 3.

¡If noise appears, change the RF output channel of the VCR to channel 4 by pressing PLAY for 3 sec- onds during playback. Then select the same channel (CH4) on your TV. (See “RF OUTPUT CHANNEL” on page 13 for the detail).

2Press VCR/TV on the recording VCR.

1	Insert a pre-recorded tape into the playing VCR.
2	Insert a tape with a safety tab into the
	recording VCR.
3	Press SPEED on the recording VCR to select the
	desired recording speed (SP/SLP).
4	Select the “L1” or “L2”position on the
	recording VCR.
¡When you use the A/V input jacks on the back of the
DVD/VCR, select "L1" position by pressing [0], [0], [1]
on the remote control or the CHANNEL buttons (o/p).
¡When you use the A/V input jacks on the front of the
DVD/VCR, select "L2" position by pressing [0], [0], [2]
on the remote control or the CHANNEL buttons (o/p).
5	Press REC/OTR on the recording VCR.
6	Begin playback of the tape in the playing
	VCR.
¡For best results during dubbing, use the VCR’s front
panel controls whenever possible. The remote con-
trol might affect the playing VCR’s operation.
¡Always use video-quality shielded cables with
RCA-type connectors. Standard audio cables are not
recommended.
¡You can use a video disc player, satellite receiver, or
other audio/video component with A/V outputs in
place of the playing VCR.		EN
	– 21 –

1L25