Sylvania CR202SL8 owner manual Watching TV, 5Channel Selection, 5Volume Adjustment

WATCHING TV

5Channel Selection

Select channels by pressing [CH K/L] or [the Number buttons].

•To select the memorized channels,

use [CH K/L] or [the Number buttons].

•To select the non-memorized channels, use [the Number buttons].

To Use [the Number buttons]

TV

-When selecting analog channel 12

1 2

DTV

-When selecting digital channel 12-1

Be sure to press [–/ENT]before entering the minor channel number.

5Volume Adjustment

This section describes how to adjust the volume. The mute function, which turns the sound off and on, is also described.

Use [VOL X/Y] to adjust the audio volume.

VOL or VOL

VOLUME 

•The volume bar will be displayed at the bottom of the TV screen when adjusting the volume.

•The volume bar display will automatically disappear in a few seconds.

–/ENT

1 2 1

•Press [CHANNEL RETURN] to return to the previously viewed channel.

•When you select a channel larger than 100,

press [+100] first. Then use [the Number buttons] to press the lower 2-digit numbers.

About digital TV broadcasting:

With its high definition broadcast, digital broadcasting far surpasses analog broadcasting in both its picture and sound quality.

What is the minor channel?

By using high compression technology, digital broadcasting offers a service that enables multiple signals to send simultaneously.

Therefore, you can select more than one program per major channel since digital broadcasting technology distinguishes between multiple channels broadcast by a single network.

Press [MUTE] to turn off and on the sound.

MUTE

MUTE 

•“MUTE” is displayed on the TV screen for a few seconds.

Press [MUTE] again or [VOL X/Y] to recover the original volume.

NTSC (analog mode)	[Air Time]	ATSC (digital mode)
	18:00	CH4		No signal		No signal
	18:30
					CH4
CH4	19:00		(high	definition		TV)
		CH4		CH4-1		No signal
	19:30	CH4
				No signal		CH4-2
	20:00
		CH4		CH4-1		CH4-2
	20:30
	major channel				minor channel

: change automatically

: change manually by using [CH/]

Although, you cannot watch the high definition TV (HDTV) program, the unit converts the HDTV signal down to the standard definition TV signal.

Note:

•“NO SIGNAL” will appear on the TV screen after the minor channel broadcast is over.

12

EN