Sylvania LD200SL9 owner manual 5Basic Connection, Antenna Cable Connection

CONNECTION

Cables not included.

Please purchase the necessary cables at your local store.

INTRODUCTION

5Basic Connection

This section describes how to connect the unit to an antenna, cable receiver or satellite box.

Note:

• Be sure your antenna or other device is connected properly before plugging in the power cord.

[Antenna Cable Connection]

When connecting the unit to an antenna or cable TV signal (without receiver/satellite box)

Connect the RF coaxial cable on your home outlet to the antenna input jack of this unit.

e.g.)

VHF / UHF

antenna rear of this unit

RF coaxial cable

or

cable TV

signal

*Once connections are completed, turn on the unit and begin initial setup.

Channel scanning is necessary for the unit to memorize all available channels in your area. (Refer to “Initial Setup” on page 12.)

Note:

•If you have any question about the DTV’s antenna, visit www.antennaweb.org for further information.

•For your safety and to avoid damage to device, please unplug the RF coaxial cable from the antenna input jack before moving the unit.

•If you use an antenna to receive analog TV, it should also work for DTV reception. Outdoor or attic antennas will be more effective than set- top versions.

•To easily switch your reception source between antenna and cable, install an antenna selector.

•If you connect to the cable system directly, contact the CATV installer.

[Connection to Cable Receiver or Satellite Box]

Use an RCA component video cable to connect the component video input jack of the unit to the component video output jack of the cable receiver / satellite box.

If you connect to the unit’s component video input jack, connect RCA audio cable to the audio L/R jack of VIDEO2.

CONNECTION INITIAL SETTING WATCHING TV OPTIONAL SETTING TROUBLESHOOTING

e.g.)

satellite

dish

or

cable TV signal including PPV

(green) (blue) (red)

AUDIO OUT COMPONENT VIDEO OUT rear of this unit

L R Y Pb/Cb Pr/Cr

ANT IN

RF coaxial

cable

RCA component video cable

STEREO

PCM

RCA audio cable cable receiver / satellite box

(green)	(blue)		(red)
Y	Pb		Pr	L	R
COMPONENT					AUDIO
		VIDEO 2
COAXIAL	S-VIDEO		VIDEO	L	R
					AUDIO

VIDEO 1

INFORMATION

*You can also connect this unit to the cable receiver or satellite box other than the component video output jack because they might have different output jacks.

*Required cables and connecting methods of the cable receiver / satellite box, or the availability channel for the clear QAM may differ depending on the cable/satellite provider. For more information, please contact your cable/satellite provider.

9

EN