TechniSat 100Hz Television sets Colani-TV Classic Line instruction manual Initial Operation

Page 3

Operating the equipment correctly

Connect to power supply 230V/50Hz AC

The TV set is designed to receive and reproduce only sound and video signals.

The set is designed to be connected only to audio and video equipment, antenna installations and computers that comply with DIN standards, and carry a CE certification.

The set may be used for private and commercial purposes, and must be operated inside a dry room, and under supervision.

Any other form of operation is specifically exclu- ded.

Manufacturer’s declaration

This equipment complies with the following stan- dards:

Radiation (X-Ray) regulations (RöV in Germany) of 08.01.1987,

EU guideline 73/23/EEC (low-voltage regulations) - EN 60065

EU guideline 89/336/EEC (EMV guideline)

-EN 55013, EN 55020, EN 60555-2 And carries CE certification.

Disposal advice

Spent batteries should not be discarded with dome- stic refuse. They can either be disposed of by sepa- rate channels, or they will collected by the dealer.

Should the TV set reach the end of its lifespan after many years, specialist retailers will take it back for environmentally-friendly disposal

TechniSat provides a coupon for an old TV set when you purchase a new set.

Cleaning and care

The housing of a Colani-Line set can be cleaned with a soft, slightly moist cloth.

The housing of a Classic Line set can be cleaned with a soft, dry cloth.

Do not use spray cleaners or any aggressive chemi- cal detergents for the housing, as this may damage the high-quality surface.

The screen can be cleaned while the set is switched off, using a dry or very slightly damp cloth.

Initial Operation

Safety advice

If the following safety precautions are ignored, the manufacturer's responsibility ceases.

Never open the housing!

It is extremely dangerous to touch parts carry- ing high-voltage current.

Only trained personnel may carry out repairs.

Should the set be delivered or transported during cold weather, do not switch it on immediately, but allow the set to adjust to room temperature first.

Operate the set in an environment where it is safe from humidity and damp, as well as splashes or drops of water. If water gets into the housing, immediately disconnect the power supply and call a service technician.

Do not place the set in very confined bookshelves or cupboards, and allow at least 10cm space all round for ventilation.

Do not place the TV set near a heater or other equipment that will cause the set to heat up more than usual.

Do not expose the set to strong sunlight, and never cover up the ventilation slots, as this would affect the cooling of the set.

In case of electrical storms, disconnect both the antenna and power connections, as power surges can damage the set.

Do not stick any objects into or through the ventila- tion slots.

If you notice a specific defect, or if there is a stran- ge smell and smoke coming from the set, dis- connect the power supply immediately, and call a technician.

If you are out of the house for an extended period of time, the TV set should be switched off. This saves energy, and prolongs the lifespan of the pic- ture tube.

If the set is kept in standby mode via the remote control, power consumption is approximately 1 Watt.

2

Image 3
Contents For 100Hz Television sets Contents Operating the equipment correctly Initial OperationYour Initial Operation has been successfully con- cluded Operation and SafetyRemote control Control elementsBack panel sockets Daily Operation Freeze Frame Selecting Sound ModeSwitching to radio reception radio mode Displaying Time, Date and InformationTele text Picture settings SettingsSound Settings Channel settings Programming for Satellite Channels NameDecoder EC1 Tele Text LanguageAudio Type Sat Selecting SatellitePolarisation FrequencyMode Radio Mode Decoder ModeAmplification Contrast Automatic scan of channels TTS Change OrderInsert Programme Programme Change ProgrammesCopying a programme Delete ProgrammeSatellite Selection KHz SignalSetting LOF V/ LOF H Satellite Settings PolarityLNB Supply Position DiSEqC offPosition DiSEqC on DiSEqCCopying between two video recorders AV ConfigurationConnecting AV equipment Connecting a video recorder VHS /VideoCopying from Camcorder to Video recorder Connecting a video recorder to the antenna socketConnecting a component with RGB outputs Playback from a camcorderClock Time Timer / ClockProgramme Timer TV set has an internal clock, as well as several timersSleeptimer Connecting a HI-FI systemHeadphone Connection VGA/ Computer Connection VGA/ Computer ConnectionVGA Computer Connection ADR Audio Types Stroring new ADR programmes in memoryADR-Scan Storing an ADR programme in memoryTechnical Terms Glossary Index of keywords Trouble-shooting guideProgramme Allocation Tables SVM Technical DataSelecting sound mode Switching the TV set on or offSwitch key for previous programme Adjusting volumeKey functions of the remote control unit Display hint Freeze frameDisplay clock time Zoom only in 169 sets