External Control Device Setup
20. Auto Sleep (Command2 : n)
GIf there is no input signal, the set turn off automatically after 10 minutes.
Transmission
[k][n][ ][Set ID][ ][Data][Cr]
Data 0: Off | 1: On |
Acknowledgement
[n][ ][Set ID][ ][OK][Data][x]
21. Horizontal Shift (Command2 : v)
GTo adjust picture to left/right as you prefer.
Transmission
[k][v][ ][Set ID][ ][Data][Cr]
Data 0 : 0~c6
Acknowledgement
[v][ ][Set ID][ ][OK][Data][x]
22. Vertical Shift (Command2 : w)
GTo adjust picture to up/down as you prefer.
Transmission
[k][w][ ][Set ID][ ][Data][Cr]
Data 0 : 0 ~ 27
Acknowledgement
[w][ ][Set ID][ ][OK][Data][x]
23. Auto Configure (Command2 : ~)
GTo adjust picture position and minimize image shaking automatically. It works only in RGB (PC) mode.
Transmission
[k][~][ ][Set ID][ ][Data][Cr]
Data 1: Auto Configure start
Acknowledgement
[~][ ][Set ID][ ][OK][Data][x]
24. Reset (Command2 : !)
GTo return to the good picture reproduction programmed at the factory and cannot be changed.
Transmission
[k][!][ ][Set ID][ ][Data][Cr]
Data 1 : Reset start
Acknowledgement
[!][ ][Set ID][ ][OK][Data][x]
25. On screen language selection (Command2 : ^)
GTo select your desired language.
Transmission
[k][^][ ][Set ID][ ][Data][Cr]
Data 0 : English
1: French
2: Spain
Acknowledgement
[^][ ][Set ID][ ][OK][Data][x]
38