Panasonic AJ- HD3700B manual FF Status Output Activel

Connector signals

Pin no.	Signal	Direction	Type	Description
29	FF STATUS	OUTPUT	ACTIVE_L	This becomes active when the VTR is in the FF mode.
30	REW STATUS	OUTPUT	ACTIVE_L	This becomes active when the VTR is in the REW mode.
31	STOP STATUS	OUTPUT	ACTIVE_L	This becomes active when the VTR is in the STOP mode.
32	RE-422 REMOTE	OUTPUT	ACTIVE_L	This becomes active when the RS-422 REMOTE status is
	ON STATUS			ON.
33	EJECT STATUS	OUTPUT	ACTIVE_L	This becomes active when a cassette tape has not been
				inserted.
34	ERR 2 STATUS	OUTPUT	ACTIVE_L	Refer to the 50P error status output table on the previous
				page. (This pin is related with pins 21 and 24.)
35	TC SOURCE	OUTPUT	ACTIVE_L (1)	11: INT	10: EXT_LTC
36	STATUS		Open (0)	01: S_VITC (EXT VITC) 00: S_LTC		[Pin 36, pin 35]
37	TC SLAVE	OUTPUT	ACTIVE_L (1)	[Pin 38, pin 37] TC SOURCE
	STATUS		Open (0)	At INT setting	At EXT setting	Other
				11: PRESET	SLAVE	–––––
38
				10: AUTO	DIRECT	–––––
				01: –––––	–––––	–––––
				00: SLAVE	–––––	–––––
39	REC INH MENU	OUTPUT	ACTIVE_L (1)	[Pin 40, pin 39]
	STATUS		Open (0)	11: FREE	10: ALL
40
				01: NRML, REC
41	CUE STATUS	OUTPUT	ACTIVE_L	This becomes active when the preroll or cue-up operation
				has been completed. However, the active status is
				released when the VTR has moved from the STBY ON or
				OFF operation to another operation.
42	REMOTE STATUS	OUTPUT	ACTIVE_L	This becomes active when 50P parallel control is enabled.
43	CASSETTE INH	OUTPUT	ACTIVE_L	This becomes active when the VIDEO/CTL recording
	1 STATUS			setting for CASSETTE INH has been set to inhibit.
				(However, the active status is forcibly released when
				CASSETTE INH 2 [pin 45] is set to ACTIVE.)
44	PRE CTL	OUTPUT	ACTIVE_L	This becomes active when CTL has been detected at the
	DETECT			PRE CTL head during normal recording at the PRE CTL
				setting.
				Note: This will not become active even if CTL has been
				detected during recording (EDIT REC) or PLAY
				while editing is being performed.
				In the same way, it will not become active even if
				CTL has been detected during normal recording
				when the home menu function (REC INH) setting
				has been set to FREE.
45	CASSETTE INH	OUTPUT	ACTIVE_L	This becomes active when CASSETTE INH has been set
	2 STATUS			to the all recording inhibit status.
46	STBY STATUS	OUTPUT	ACTIVE_L	This becomes active when the VTR has been placed in
				the STBY ON status.
				The ACTIVE lamp flashes (at 2-second intervals) starting
				30 seconds before the VTR is transferred to the loosing mode.
				It flashes (at 0.5-second intervals) starting 10 seconds
				before the VTR is transferred to the STBY OFF mode.
47	GND	OUTPUT		GND
48	LOCAL STATUS	OUTPUT	ACTIVE_L	This becomes active when the REMOTE OP MAP
				functions are enabled.
49	GND	OUTPUT		GND
50	GND	OUTPUT		GND

– 47 –