Panasonic AJ- HD3700B ∑ Parallel I/O 50P connector, Pin no Signal Direction Type Description

Connector signals

∑PARALLEL I/O (50P) connector

(1) PULSE SIGNAL: The signal fall is detected and the signal becomes active.

Pin no.	Signal	Direction	Type	Description
1	REC COMMAND	INPUT	PULSE SIGNAL	When this signal becomes active simultaneously with the
				play command, it transfers the VTR to the REC PLAY
				mode. However, the VTR is not transferred to the REC
				mode if the insert or assemble mode has been set.
2	PLAY COMMAND	INPUT	PULSE SIGNAL	This transfers the VTR to the PLAY mode.
3	FF COMMAND	INPUT	PULSE SIGNAL	This transfers the VTR to the FF mode.
4	REW COMMAND	INPUT	PULSE SIGNAL	This transfers the VTR to the REW mode.
5	STOP COMMAND	INPUT	PULSE SIGNAL	This transfers the VTR to the STOP mode.
6	STBY ON	INPUT	PULSE SIGNAL	When the VTR is in the loosing or STBY OFF mode, it is
	COMMAND			set to the STNBY ON mode as soon as it receives this
				command.
7	STBY OFF	INPUT	PULSE SIGNAL	When the VTR is in the loosing or STBY ON mode, it is
	COMMAND			set to the STNBY OFF mode as soon as it receives this
				command.
8	RS-422 REMOTE	INPUT	PULSE SIGNAL	This enables RS-422 control. However, the VTR must be
	ON COMMAND			in the REMOTE mode for this command to take effect.
9	RS-422 REMOTE	INPUT	PULSE SIGNAL	This disables RS-422 control.
	OFF COMMAND
10	LOCAL ENABLE	INPUT	PULSE SIGNAL	This enables the REMOTE OP MAP functions. When the
	COMMAND			MAP MODE is set to ALL, it also enables EJECT.
11	EJECT COMMAND	INPUT	PULSE SIGNAL	This transfers the VTR to the EJECT mode.
12	ENTRY	INPUT	PULSE SIGNAL	When this signal has become active, the VTR’s current
	COMMAND			time (TC, CTL) is entered on the following menus:
				When the VTR has opened the HOME menu:
				≥The time is entered in CUE TIME on the HOME menu.
				When the VTR has opened the AUTO EDIT menu:
				≥The time is entered in CUE TIME on the HOME menu.
				≥The time is entered at the IN point on the AUTO EDIT
				menu.
				When the VTR has opened the EXTEND MULTI CUE
				menu:
				≥The time is entered at the cursor position of the EXTEND
				MULTI CUE menu.
				When the VTR has opened the MULTI CUE menu:
				≥The time is not entered on any of the menus.
				When the VTR has opened a menu other than the ones
				above:
				≥The time is entered in CUE TIME on the HOME menu.
13	ALL_REC_INH_	INPUT	PULSE SIGNAL	This selects ALL as the REC INH menu setting.
	ON COMMAND
14	PRE_CTL_INH_	INPUT	PULSE SIGNAL	This selects PRE_CTL as the REC INH menu setting.
	ON COMMAND
15	LOCAL DISABLE	INPUT	PULSE SIGNAL	This disables the REMOTE OP MAP functions.
	COMMAND			When the MAP MODE is set to ALL, it also disables
				EJECT.

– 45 –