Tape Operation
Search System
For each recording, an invisible index mark is placed on the tape. A program index and information are also included for timer recordings. These marks are used to access or scan recordings.
Index Search
1 | Press SEARCH* |
to display SEARCH | |
| in Stop or Play |
| mode, and then |
| press NUMBER |
| keys to select |
| recording number. |
| • To calculate number, |
| see below. |
| Press FF/SLOW+ or |
| REW/SLOW- on the |
| remote to start |
| search. |
|
|
2 | Play begins at |
search end. |
To search forward or back 1 index, press FF/SLOW+ or REW/SLOW- on the remote while screen left is displayed (10 sec.).
• To cancel, press PLAY or STOP.
To Calculate Index Number
Example 1:
To go to rec. 2 from rec. 4, enter 3 and press REW.
1 | 2 | 3 | 4 |
| 5 | 6 | 7 |
|
|
|
|
|
|
|
|
Zero Search
To quickly return to a specified tape location.
1 Press DISPLAY during play to display Counter.
2 | Press COUNTER |
RESET on remote at |
desired position to reset to “0:00:00”.
3Continue to record, playback etc.
4Press STOP.
5 | Press CM/ZERO |
in Stop mode to start |
Zero Search.
•DECK will go into FF or REW mode and stop at the last point the Counter was set to 0:00:00.
Commercial Skip
DECK fast forwards (skips) over 1, 2, or 3 minutes of recorded tape as desired.
1Press CM/ZERO in Play mode.
•The skip time can be changed by pressing CM/ZERO repeatedly as shown by the figure below.
Example 2:
PLAY
To go to rec. 6 from rec. 2, enter 4 and press FF. | 1st Press | 1 min Skip |
|
1
2
3
4
5
6
7
2nd Press | 2 min Skip |
NOTE: |
| indicates start points of each recording. | 3rd Press |
| 3 min Skip |
| |||||
|
|
Note
•If Index Search is started very close to an index mark, that index mark may not be counted in the search.
• No indication appears
30 | For assistance, please call : |
| |
|