Initial Setup for Basic Connections (Ready to Play)
Before doing Initial Setup
1 Turn TV on.
2 See connections a RF Coaxial Cable Connection and b AV Cable Connection on page 12.
<RF Coaxial Cable Connection> Set TV to channel 3.
<AV Cable Connection> Set TV to VIDEO.
3 [DECK ➛ TV]
• Go to “Initial Setup (Ready to Play).” (See below.)
[Cable Box ➛ DECK ➛ TV], [DSS ➛ DECK ➛ TV]
•Turn on Cable Box and set it to your Public Broadcasting Station (PBS) channel in your time zone.
•If you use a DSS Receiver, it must be turned off.
Initial Setup (Ready to Play)
1
2
Press VCR on remote for VCR mode.
Plug DECK Power Cord into AC wall outlet. DECK comes on and auto channel and clock set starts.
•If screen below does not appear, check DECK - TV connection and, if TV is tuned to channel 3, try switching it to channel 4.
•To change VCR’s output channel, please refer to “VCR’s Output Channel” on page 19.
Plugging the AC Power Plug into an AC outlet.
CH AUTO SET PROCEEDING
CANCEL : STOP
AUTO CLOCK SET
PROCEEDING
Notes
•Function buttons are inoperative during Initial Setup.
•To remove a cassette during Auto Set, press EJECT on the remote or STOP/EJECT twice on the DECK.
In this case, settings must be made manually. (See p. 18.)
•Depending on conditions, Auto Clock Set may take longer than 30 minutes. If so, press STOP to stop setup and perform settings manually. (See p. 18.)
CANCEL : STOP
Continued on next page...
16 | For assistance, please call : |
| |
|