Panasonic PV-D4761 operating instructions Multiple Angle Viewing DVD only, Press Angle, Or Angle

Page 41

*Important: if a remote control button does not work when pressed, press the DVD button on the remote and try the button again.

When appears on the screen while a button is being operated, it means that the corresponding operation is prohibited by DECK or the disc.

ANGLE Indicator

Notes

The ANGLE Indicator lights up on DECK when a scene recorded at different angles is detected.

The angle number can be set beforehand so that the angle is switched whenever the ANGLE Indicator lights up.

Multiple Angle Viewing (DVD only)

DVDs may contain scenes shot from multiple camera angles allowing the same scene to be viewed at different angles. You can view these angles, if available, using the ANGLE button.

1

ANGLE : 1

Press ANGLE

ANGLE : 1

 

 

 

in Play mode to display the

 

 

angle selection on-screen.

 

 

• Display disappears after

 

 

5 seconds.

 

SELECT :

SET : SET

 

 

SELECT :

SET : SET

 

2

ANGLE : 2

Press

or ANGLE

LE : 2

 

 

 

to select the desired angle.

 

SELECT ::

SETT::SET

 

Number of angle being played back.

Vocal Selection for Karaoke Discs (DVD/Video CD)

1 Press AUDIO in Play mode to display the audio screen.

2 AUDIO:2 ENG VOCAL ON

SET

SELECT

SELECT :

Press (or )

to select as shown below, and

press (or ) to set. (DVD only)

SET : SET

SUB TITLE

• DVD Karaoke (1 vocal) VOCAL ON VOCAL OFF

• DVD Karaoke (2 vocals) VOCAL V1 + V2 VOCAL V1 VOCAL V2 VOCAL OFF

 

 

 

 

 

 

 

ZOOM

• Video CD

LR L R

 

 

 

 

 

 

ANGLE

 

 

 

 

 

 

AUDIO

Picture Zoom (DVD only)

 

 

 

 

 

 

You can enlarge specific portions of a picture and select the zoom ratio using the ZOOM button in Play mode.

DVD Operation

Notes

The subtitle cannot be enlarged nor can it’s position be changed.

The picture zoom feature does not work with a Video CD.

During picture zoom, “ZOOM1” or “ZOOM2” is displayed on-screen.

Zooming, on some discs, may result in poor picture quality, or not operate.

Press ZOOM repeatedly

to change display as follows.

You can enlarge the center portion of the image to one of 2 magnifications.

X 1.0 (ORIGINAL)

X 1.5 (ZOOM 1)

X 2.0 (ZOOM 2)

1st press

 

2nd press

Hello!lo!

Hello! ZOOMZOOM11

Hello! ZOOMZOOM22

 

 

3rd press

Use the , , and buttons to move the position up, down, left and right.

41

Image 41
Contents Model No. PV-D4761 Operating InstructionsImportant Safeguards and Precautions FCC Caution Region Management InformationInside of product Accessories Before UsingDisc Handling Loading the BatteriesTable of Contents Deck & Cassette Information Definition of Terms DVD SpecificationsLight Tower Universal Remote Control Remote ControlLocation of Controls Number keysSTOP/EJECT Fast FORWARD/SEARCH Play REWIND/SEARCH Front View of DeckChannel TRACKING/V-LOCK RECRear View of Deck Multi Function Display Displays On Screen & Multi FunctionOn Screen Displays VCR Basic Connections ConnectionsDSS Receiver Deck TV Deck TV Cable Box Deck TV OUTDeck Cable Box TV Other Connections You CanConnect With Two Cable Boxes Connections For DVD OnlyAudio Connections Ready ChecklistDeck Amplifier Speaker DVDFirmly connect the cable to the connector To Optical Digital Audio Input ConnectorHow to do Initial Setup Initial Setup for Basic ConnectionsPower VCR VCR/TV Action Select SET DECK-TVPress SET to enter Press CH Reset All Memory FunctionsPress Action to display Manual Clock Set screen Press Action twiceTo display Menu Reset Language, Channels, ClockPress Action DST Daylight Saving Time VCR’s Output ChannelAdd or Delete a Channel Playback/ Record on a Tape Playback using Deck buttonsRapid Rewind/FF REW/SLOW VCR/TV StopRecord using Deck buttons Basic DVD Operation Operation using Deck buttonsTo return to menu play stops Press OPEN/CLOSEResume Function Auto-Power Off FunctionSurround Sound System ADD/DLT Prog VCR+ Select SET Timer RecordingOperation Press SET or Action Timer Recording Using VCR Plus+ SystemVCR Plus+ System is Important NoteIf channel updating If VCR could not Was successful Before you perform the following steps, you should haveTo select channel map for Your areaChannel Setup Initial SetupPress Action three times to end setup To Make CorrectionsPress Number keys Press PROG/VCR+ button to display SET ProgramPress repeatedly Action ADD/DLT Prog VCR+ Select SETDisplay Audio MTS Broadcast/ VHS Hi-Fi Stereo SystemReceivable Broadcast Types Audio Mode for Playback Audio Mode for RecordingUsing Multi-Brand Control Multi-Brand Control FeatureMulti-Brand Control Setup Cable Box Brand Code Numbers TV Brand Code NumbersDSS Brand Code Numbers Important NotesIndex Search Tape OperationProgram End Search REW/SLOWAuto Play Auto Operation FunctionsAuto Rewind Commercial SkipStop Action Select SET Display CM/ZERO Counter Reset Press Counter ResetRepeat Play Zero SearchWeak Signal Display Feature VCR Lock FeatureAuto Shut-Off Feature To turn onRemote WARNING, Tape Position and Tape Status FeaturePress Tape Position To detect current tape positionPlaying Source VCR Recording Editing Deck Copying Your Tapes DubbingPress SUB Title Subtitle Language DVD onlyAudio Soundtrack Language DVD only Press Angle Multiple Angle Viewing DVD onlyOr Angle Vocal Selection for Karaoke Discs DVD/Video CDTitle Menu DVD only Disc OperationDVD Menu DVD only Press SET or Play to performProgram Repeat Play Video CD/CD Program Play Video CD/CDTo select Play Mode To select SET UP DVDRandom Play Video CD/CD To begin random playTo select the setting, and press SET DVD Operation using On-Screen DisplaysTo select an item, and press SET Example of DVDDisc information screen for DVD Detailed Descriptions of each On-Screen DisplayDisc information screen for Video CD/ CD Title NoDeck information screen Play mode Video CD/ CD only See p orFor your reference TRACK/DISC Repeat Play Video CD/CDUnlocked DVD Lock DVD onlyPress Number keys to enter your secret code Disc Languages DVD only Settings for DVD OperationDisc Languages See below Audio Output See pAudio Output TV Mode Still ModePress Action twice to exit this mode ExampleCode Language Language Code ListIf Deck is not in Stop mode or a cassette If you attempt to set or review a TimerIf you press REC on the remote control or Remote control or Deck without a Cassette insertedRecording & Playback Correction Power CorrectionRemote Control Correction Miscellaneous Correction DVD/ Video CD/ CD CorrectionHollywood, FL Service in Puerto RicoLimited Warranty Como realizar la Configuració n Inicial Operaciones básicas para la grabació n Programació n fá cil para la grabació n con temporizadorOperaciones bá sicas del DVD Ejemplo de DVD Ejemplo de Video CD Para volver a la pantalla normalPresione repetidamente Clear o Display Cambio del idioma de subtítulos DVD solamente Fijaciones inicialesSelecció n de Idiomas DEL Disco DVD solamente Seleccione AudioSelecció n de vocal para los discos de Karaoke DVD/Video CD Visió n desde otro á ngulo DVD solamenteAmpliació n de la imagen DVD solamente Presione o las teclas de nú merosS0401-0 Deck & VCR