Pelco Dx8000 manual Move the Front and Rear Cross-Braces, Removing Front and Rear Cross-Braces

Page 10

Move the Front and Rear Cross-Braces

1.Unscrew and lift out both the front and rear cross-braces. Moving these parts out of the way will make it easier for you to access the hard drive mounting baskets and PCI Slot 6.

a.Use a Phillips-head screwdriver to remove the two flat-head screws that secure each cross-brace. Refer to Figure 6.

Figure 6. Removing Front and Rear Cross-Braces

8

C1609M (6/04)

Page 9 Page 11
Image 10
Page 9 Page 11
Contents DX8000 Page Introduction Parts ListTools Needed Removing Power Cord from Wall Getting ReadyRemoving Power Cord from Unit ESD Protection Prepare Unit for Drive Installation Open the Unit ChassisRemoving Chassis Cover Component Layout DX8000 InteriorMove the Front and Rear Cross-Braces Removing Front and Rear Cross-BracesPlacing Front and Rear Cross-Braces Out of the Way Disconnect the Data and Power Cables Removing IDE Data CablesRemoving Hard Drive Power Connections Remove the Drive Mount Baskets Removing Hard Drive BasketInstall Additional Drives Prepare the DrivesMount the Additional Drives Inserting Drives into BasketReplacing Drive Baskets SET the Master / Slave Jumpers Setting Drive Jumpers Install the DX8000-EXD IDE Extender Card Location of PCI SlotPCI Slot 6 Slot Cover Inserting the DX8000-EXD IDE Extender Card Securing the DX8000-EXD IDE Extender Card Reconnect Data and Power Cables Installing the CD-RW Data Cable to the Extender Card Installing Hard Drive Data Cables Installing Hard Drive Power Connectors Reassemble the Unit Replacing Front Cross-BraceReplacing Chassis Cover Restarting Unit Initialize the New Drives to Store Data Opening List of DrivesSelecting Allocation Option for Each Drive Format Warning Dialog Box C1609M 6/04 Product Warranty and Return Information ISO9001
Related manuals
Manual 32 pages 20.54 Kb Manual 10 pages 26.21 Kb Manual 40 pages 3.7 Kb Manual 1 pages 21.57 Kb
Top Page Image Contents