Pelco Dx8000 manual Mount the Additional Drives, Inserting Drives into Basket

Page 16

MOUNT THE ADDITIONAL DRIVES

1.Mount the hard disk drives in the drive baskets. Refer to Figure 12 below.

a.Make sure drives are mounted in the baskets so that access to connectors is not blocked.

b.Attach each drive to the basket using the two screws that came with the upgrade kit.

c.Tighten the screws securely but do not over-tighten.

Figure 12. Inserting Drives into Basket

14	C1609M (6/04)

Image 16

Contents DX8000 Page Introduction Parts ListTools Needed Removing Power Cord from Wall Getting ReadyRemoving Power Cord from Unit ESD Protection Prepare Unit for Drive Installation Open the Unit ChassisRemoving Chassis Cover Component Layout DX8000 InteriorMove the Front and Rear Cross-Braces Removing Front and Rear Cross-BracesPlacing Front and Rear Cross-Braces Out of the Way Disconnect the Data and Power Cables Removing IDE Data Cables Removing Hard Drive Power Connections Remove the Drive Mount Baskets Removing Hard Drive BasketInstall Additional Drives Prepare the DrivesMount the Additional Drives Inserting Drives into BasketReplacing Drive Baskets SET the Master / Slave Jumpers Setting Drive Jumpers Install the DX8000-EXD IDE Extender Card Location of PCI SlotPCI Slot 6 Slot Cover Inserting the DX8000-EXD IDE Extender Card Securing the DX8000-EXD IDE Extender Card Reconnect Data and Power Cables Installing the CD-RW Data Cable to the Extender Card Installing Hard Drive Data Cables Installing Hard Drive Power Connectors Reassemble the Unit Replacing Front Cross-BraceReplacing Chassis Cover Restarting Unit Initialize the New Drives to Store Data Opening List of DrivesSelecting Allocation Option for Each Drive Format Warning Dialog Box C1609M 6/04 Product Warranty and Return Information ISO9001

Related manuals

Manual 32 pages 20.54 Kb

Manual 10 pages 26.21 Kb

Manual 40 pages 3.7 Kb

Manual 1 pages 21.57 Kb