Pelco Dx8000 manual Restarting Unit

Page 30

3.Reinstall the unit in a rack enclosure if necessary, and reconnect all cables and peripheral equipment that you removed earlier.

4.Plug the power cord back into the power supply and then into the wall.

5.Turn on the power switch and allow the unit to start up and find the new hard disks. This may take up to five minutes.

ON/OFF

Figure 25. Restarting Unit

28

C1609M (6/04)

Page 29 Page 31
Image 30
Page 29 Page 31
Contents DX8000 Page Parts List IntroductionTools Needed Removing Power Cord from Wall Getting ReadyRemoving Power Cord from Unit ESD Protection Prepare Unit for Drive Installation Open the Unit ChassisRemoving Chassis Cover Component Layout DX8000 InteriorMove the Front and Rear Cross-Braces Removing Front and Rear Cross-BracesPlacing Front and Rear Cross-Braces Out of the Way Disconnect the Data and Power Cables Removing IDE Data CablesRemoving Hard Drive Power Connections Remove the Drive Mount Baskets Removing Hard Drive BasketInstall Additional Drives Prepare the DrivesMount the Additional Drives Inserting Drives into BasketReplacing Drive Baskets SET the Master / Slave Jumpers Setting Drive Jumpers Install the DX8000-EXD IDE Extender Card Location of PCI SlotPCI Slot 6 Slot Cover Inserting the DX8000-EXD IDE Extender Card Securing the DX8000-EXD IDE Extender Card Reconnect Data and Power Cables Installing the CD-RW Data Cable to the Extender Card Installing Hard Drive Data Cables Installing Hard Drive Power Connectors Reassemble the Unit Replacing Front Cross-BraceReplacing Chassis Cover Restarting Unit Initialize the New Drives to Store Data Opening List of DrivesSelecting Allocation Option for Each Drive Format Warning Dialog Box C1609M 6/04 Product Warranty and Return Information ISO9001
Related manuals
Manual 32 pages 20.54 Kb Manual 10 pages 26.21 Kb Manual 40 pages 3.7 Kb Manual 1 pages 21.57 Kb
Top Page Image Contents