SENDING AUXILIARY COMMANDS TO A DEVICE
The DX4500/DX4600 auxiliary feature allows you to control external equipment connected to the auxiliary outputs of Spectra domes or Esprit® positioning systems. The auxiliary function is implemented through Pelco D and Pelco P protocols.
The AUX key selects the auxiliary mode. Buttons
For example, an Esprit equipped with a wiper uses Aux 1 to control the wiper. In this case, sending an AUX 1 command to the Esprit operates the wiper. You must configure the camera to establish how the camera responds to an auxiliary command. For detailed information about how a specific Spectra or Esprit camera system interprets auxiliary commands, refer to the documentation that accompanies the camera system.
To send an Aux 1 command to operate the wiper on an Esprit:
1.On the front panel or remote control, press any of the arrow buttons 
to select a PTZ camera. Using the mouse, click the camera.
2.On the front panel or remote control press PTZ. Using the mouse, click the PTZ button 
. The PTZ control is displayed.
3.Enter the PTZ programming mode.
•On the front panel, press SHIFT + SET.
•On the remote control, press SET.
•Using the mouse, click SET.
4.Send an AUX 1 command.
•On the front panel, press SHIFT + AUX, and then press 1.
•On the remote control, press AUX, and then press 1.
•Using the mouse, click AUX, and then click 1.
The wiper operates one cycle.
PTZ PRESETS
A preset is a
Programming a Preset
1.On the front panel or remote control, press any of the arrow buttons 
to select a PTZ camera pane. Using the mouse, click a camera pane.
2.On the front panel or remote control, press PTZ. Using the mouse, click the PTZ button 
. The PTZ control is displayed.
3.Position, zoom, and focus the camera.
a.On the front panel or remote control, press any of the arrow buttons 
to move the camera. Using the mouse, click the
Move buttons 
.
b.On the front panel, press SHIFT + ZOOM or remote control, press ZOOM. Using the mouse, click ZOOM.
c.On the front panel, press SHIFT + FOCUS- or FOCUS+. On the remote control, press FOCUS. Using the mouse, click FOCUS.
4.Store the preset to a memory location.
a.On the front panel, press SHIFT + SET or remote control, press SET. Using the mouse, click SET. The camera is now in the programming mode.
b.On the front panel or remote control, press a number representing the preset memory location. Using the mouse, click a number on the keypad.
c.On the front panel, press SHIFT + PRESET. On the remote control, press PRESET. Using the mouse, click PRESET. The camera’s position, zoom factor, and focus setting are stored to the memory location.
5.Do one of the following:
• To create multiple presets for the same camera, repeat steps 3 and 4.
• To exit the programming mode, on the front panel, press SHIFT + SET. On the remote control, press SET. Using the mouse, click SET.
101 |