Pelco DX4600 PTZ Patterns, Verify that you can activate the preset, Stop programming the pattern

6.Verify that you can activate the preset.

a.On the front panel or remote control, press any of the arrow buttons to move the camera to another location. Using

the mouse, click the Move buttons .

b.If you changed the camera’s zoom or focus, verify that the settings are different than the preset settings.

c.Do one of the following:

•On the front panel, press the preset number, and then press SHIFT + PRESET.

•On the remote control, press the preset number, and then press PRESET.

•Using the mouse, click the preset number, and then click PRESET.

The camera performs the programmed preset.

Preset Tours

A preset tour allows a camera to move through a programmed sequence of PTZ presets. The DX4500/DX4600 tour advances sequentially through presets 1–16. There is approximately a four-second pause between the end of the current preset and the start of the next preset. If the presets are programmed sequentially (1, 2, 3, 4, and so forth), the time period between presets is brief. If one or more of the presets are not programmed sequentially, the time period between the end of the current preset and the start of the next can be longer, because the system still accounts for the four-second interval for the non programmed preset memory location. For example, if presets 1 and 2 are programmed and presets 3–16 are not programmed, the system waits approximately 54 seconds before starting preset 1.

A preset tour will operate continuously until another PTZ control action is performed. At least one PTZ preset must be set in order to create a preset tour.

To activate a preset tour:

1. Click the PRESET button without entering a preset number. This activates a preset tour for all PTZ-enabled cameras.

Clearing a Preset

1.On the front panel, press SHIFT + SET. On the remote control, press SET. Using the mouse, click SET.

2.On the front panel, press SHIFT + PRESET. On the remote control, press PRESET. Using the mouse, click PRESET.

3.On the front panel or remote control, press a number representing the preset memory location. Using the mouse, click a number.

4.On the front panel, press SHIFT + CLR. On the remote control, press CLR. Using the mouse, click CLR. The preset is cleared from the camera’s memory.

PTZ PATTERNS

Programming a Pattern

1.On the front panel, press SHIFT + SET or remote control, press SET. Using the mouse, click SET. The camera is now in the programming mode.

2.On the front panel or remote control, press a number representing the pattern (1–4). Using the mouse, click a number.

3.On the front panel, press SHIFT + PATTERN. On the remote control, press PATTERN. Using the mouse, click PATTERN.

(Certain PTZ devices, such as Pelco’s Spectra series domes, will display an on-screen message with the amount of remaining memory available for pattern programming.)

4.Move the camera through a series of movements using the on-screen PTZ and focus controls.

a.On the front panel or remote control, press any of the arrow buttons to move the camera. Using the mouse, click the

Move buttons .

b.On the front panel, press SHIFT + ZOOM or remote control, press ZOOM. Using the mouse, click ZOOM.

c.On the front panel, press SHIFT + FOCUS- or FOCUS+. On the remote control, press FOCUS. Using the mouse, click FOCUS.

5.Stop programming the pattern.

a.On the front panel, press SHIFT + PATTERN. On the remote control, press PATTERN. Using the mouse, click PATTERN.

b.On the front panel, press SHIFT + SET. On the remote control, press SET. Using the mouse, click SET.

102 C2674M-C (7/09)