•To clear a selected view area, do one of the following:
–On the front panel or remote control, press any of the arrow buttons 
to highlight a selected cell in the motion detection area, and then press ENTER. The cell is deselected. Repeat this process until you have deselected all of the cells.
–If using the mouse,
Figure 54. Define and Select a Motion View Area
7.Save the changes.
a.Do one of the following:
•On the front panel, press the MENU/ESC button or press the MENU/ESC button 
on the remote control until the “Configuration data is changed. Save the new settings message?” dialog box is displayed.
•Using the mouse, click Exit. “The Configuration data is changed. Save the new settings?” dialog box is displayed.
b.On the front panel or remote control, press the left/right arrow buttons 
to highlight OK, and then press ENTER. Using the mouse, click OK. The changes are saved and the Live View mode is displayed.
RELAY OUTPUTS
You can configure how the relay outputs are controlled: automatic or manual. The Relay Off setting applies globally for all relay outputs. The Relay Off option does not control the actual alarm record function. Turning off the relay output does not terminate the alarm record mode.
•Automatic: Relay out is turned off when the
•Manual: Relay Output is turned off from the front panel, remote control, or GUI.
1.From the Setup widow, on the front panel or remote control, press the up/down arrows 
to highlight Output. Using the mouse, click Output. The Output option is highlighted and the property setting is displayed.
Figure 55. Property Option Settings
2.To configure how the relay outputs respond when the alarm record mode stops, press ENTER on the front panel and remote control. Using the mouse, click Channel. The Relay Off property is highlighted.
56 |
|