Go-Video VHS-VHS, 4-Head Hi-Fi manual Setting Antenna Channel Memory, Auto Program

#

#

NOTE:

In cases of poor or weak video reception, your Tuner Setup menu may not be visible. When this happens, select a strong local channel where the menu will be visible again.

Setting Antenna

& Channel Memory

Once you have your Dual-Deck VCR hooked up to your antenna or directly to a cable system without a cable converter box, you’ll need to set the antenna and the channel memory. If you are using a cable converter box, you will need to set your VCR’s tuner channel to receive only the cable converter box output channel.

Your Dual-Deck VCR comes with a 181 channel MTS tuner capable of receiving both over-the-air and cable broadcasts in stereo. Reception for channels 2-13 are the same on regular broadcast or on cable TV. But above channel 13, cable TV (CATV) reception is different from broadcast TV.

1.Press MENU on your remote control. The Features menu will appear.

2.Press 1 . The Setup menu will appear.

3.Press 2 . The Tuner Setup menu will appear.

4.Set the ANTENNA SOURCE. Press CHANGE to cycle between TV and CATV (cable). When the desired option is on the screen, go to step 5.

5.	Press SELECT (Mute button) to move to
	AUTO PROGRAM.

6.Press CHANGE (LCV button) to begin automatic channel programming. The VCR will go through all possible TV or cable channels, and will auto- matically put the channels which you receive into Channel Memory. This will take a few minutes to complete.

7.If you wish, you can program certain channels into Channel Memory or remove them from Channel Memory manually. You can also select stereo sound. To do this, see the TUNER SETUP menu section of this manual. See page 35.

8.Press MENU to save the changes and to exit to the SETUP menu.

9.Press MENU until you exit the menu system.

CHAPTER 2 - OPERATING YOUR DUAL-DECK VCR 17