JVC LPT0428-001A, HR-S5700AM specifications Recording

							E	N	51
	RECORDING
		SYMPTOM		POSSIBLE CAUSE		CORRECTIVE ACTION
1.	Recording cannot be started.		● There is no cassette loaded, or the		Insert a cassette, or using adhesive
			cassette loaded has had its Record		tape, reseal the slot where the tab
			Safety tab removed.		was removed.
2.	TV broadcasts cannot be recorded.		● "L-1", "F-1", "S-1" or "S-2" has been		Set to the desired channel.
			selected as the input mode.
3.	Tape-to-tape editing is not possible.		● The source (another video recorder,		Confirm that the source is properly
			camcorder) has not been properly		connected.
			connected.
			● All necessary power switches have		Confirm that all units' power switches
			not been turned on.		are turned on.
			● The input mode is not correct.		Set the input mode to "L-1", "F-1", "S-
					1" or "S-2".
4.	Camcorder recording is not		● The camcorder has not been		Confirm that the camcorder is
	possible.		properly connected.		properly connected.
			● The input mode is not correct.		Set the input mode to "L-1", "F-1", "S-
					1" or "S-2".
	TIMER RECORDING
		SYMPTOM		POSSIBLE CAUSE		CORRECTIVE ACTION
1.	Timer recording won't work.		● The clock and/or the timer have		Re-perform the clock and/or timer
			been set incorrectly.		settings.
			● The timer is not engaged.		Press ‰ and confirm that "‰" is
					displayed on the display panel.
2.	On-screen timer programming is		● Timer recording is in progress.		Timer programming can't be
	not possible.				performed while a timer recording is
					in progress. Wait until it finishes.
3.	"‰" and "]" on the display panel		● The timer is engaged but there's no		Load a cassette with the Record
	won't stop blinking.		cassette loaded.		Safety tab intact, or cover the hole
					using adhesive tape.
4.	The cassette is automatically		● The loaded cassette has had its		Remove the cassette and cover the
	ejected, and "‰" and "]" on the		Record Safety tab removed.		hole with adhesive tape, or insert a
	display panel won't stop blinking.				cassette with the Record Safety tab
					intact.
5.	"‰" blinks for 10 seconds and the		● ‰has been pressed when there are		Check the programmed data and re-
	Timer mode is disengaged.		no programs in memory, or the		program as necessary, then press ‰
			timer record information has been		again.
			programmed incorrectly.
6.	The cassette is automatically		● The end of the tape was reached		The programme may not have been
	ejected, the power shuts off and "‰"		during timer recording.		recorded in its entirety. Next time make
	and "]" won't stop blinking.				sure you have enough time on the tape
					to record the entire programme.
7.	The G-CODE/SHOWVIEWsystem does		● The recorder's channel positions		Refer to "G-CODE/SHOWVIEWSystem
	not timer-record properly.		have been set incorrectly.		Setup" and re-perform the procedure.
					( pg. 24)