JVC HR-S9850EU Memory Capacity, Prepare the recording deck, Start Random Assemble Editing

EN 61

G Locate the start point.

Find the edit-in point on the source tape from where you want the edited scene to begin by pressing w e or using the JOG dial, then press PROG.

● The edit-in point is registered in memory and appears on the screen.

H Locate the end point.

Find the edit-out point where you want the edited scene to end by pressing w e or using the JOG dial, then press

PROG.

● The edit-out point is registered in memory and appears on the screen.

●The total time of the edited

scenes is displayed to the right of “(+)”.

● Repeat steps 7 and 8 for each additional scene.

I Prepare the recording deck.

Engage its Record-Standby mode.

J Start Random Assemble Editing.

Press OK.

●Automatic editing begins; all the specified scenes are copied to the recording deck in the order they were registered.

●The on-screen display remains while your recorder searches for each scene (blinking cursor indicates scene currently being searched for), but disappears during actual editing.

●During scene search, the recording deck automatically enters its Record-Standby mode.

●When all registered scenes have been edited, your recorder enters the Pause mode, the recording deck enters its Record-Standby mode, and the cursor blinks at the next available number.

K End Random Assemble Editing.

To Make Corrections ...

... in step 7 or 8, you can cancel registered in and out points by pressing &. Each time you press, the preceding point is erased.

●If, for example, you have registered 5 sets of in and out points and want to reset the first set, you have to press & until all points after the first set have been erased. Reenter them after you have repaired the first set of points.

NOTES:

●You can also monitor the sound when searching for scenes you want to edit in steps 7 – 8. Since you can hear the soundtrack during selection, you can avoid abrupt or unnatural sounding scene-to-scene transitions. The sound that is heard, however, is not TimeScan Audio.

●When editing, there may be a discrepancy of about 2 seconds on the source tape between the locations you chose as edit-in and -out points and the locations your recorder recognizes as those points.

●For any scene, the edit-out point must have a counter reading that is at least 1 second after the corresponding edit-in point. Any less than 1 second and the edit-out point will not be registered.

●Since the source recorder prerolls during Random Assemble Editing, there must be at least 15 seconds worth of recorded material prior to any edit-in point on the source tape.

●If the search time for an edit-in point exceeds 5 minutes, the recording deck enters its Stop mode and editing will not take place.

●During steps 7 and 8 — if you engage the Pause mode while registering edit-in and -out points in the R.A.Edit screen, the characters in the on-screen display may become distorted. This is normal.

Memory Capacity

Random Assemble Editing shares memory space with the recorder’s timer. If there are programmes occupied by timer-recording data, those spaces cannot be used to register edit-in and -out points

— meaning you will not be able to edit 8 scenes.

● When all 8 programmes are full, “PROGRAM FULL” appears on the R.A.Edit screen.

●To cancel a programme, see page 36.

RM-V704U Multi-Brand Random Assemble Edit Controller (Not provided)

By connecting this controller to your recorder’s R.A.EDIT connector, you can perform Random Assemble Editing in combination with a second non-JVC video recorder. The controller is compatible with various major recorder brands. For compatible systems and availability, please consult your JVC dealer.

NOTE:

Press MENU to return to the normal screen, and engage the Stop mode for your recorder and for the recording deck.

Although the RM-V704U is designed to operate the recording deck, it may not work with some recorders, or may have limited function capability.