JVC Model SR-TS1U manual Dear Customer

Page 2

2EN

Dear Customer,

Thank you for purchasing the JVC VHS video cassette recorder. Before use, please read the safety information and precautions contained in the following pages to ensure safe use of your new VCR.

CAUTIONS

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK.

DO NOT REMOVE COVER (OR BACK).

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

WARNING:

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.

CAUTION:

This video cassette recorder should be used with AC 120V‘, 60Hz only.

To prevent electric shocks and fire hazards, DO NOT use any other power source.

CAUTION:

TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

ATTENTION:

POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU'AU FOND.

Note to CATV system installer:

This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

Warning on lithium battery

The battery used in this device may present a fire or chemical burn hazard if mistreated. Do not recharge, disassemble, heat above 100°C or incinerate. Replace battery with Panasonic (Matsushita Electric), Sanyo, Sony or Maxell CR2025; use of another battery may present a risk of fire or explosion.

Dispose of used battery promptly. Keep away from children.

Do not disassemble and do not dispose of in fire.

VCR Plus+ C3 and PlusCode are registered trademarks of Gemstar Development Corporation.

The VCR Plus+ system is manufactured under license from Gemstar Development Corporation.

DSSTM is an official trademark of DIRECTV, Inc., a unit of GM Hughes Electronics. PRIMESTAR is a registered service mark of Primestar Partners, L.P. DISH NetworkTM is a trademark of Echostar Communications Corporation.

MOVIE ADVANCETM is a trademark of SRT, Inc. A Jerry Iggulden invention licensed in association with Arthur D. Little Enter- prises, Inc.

CAUTION:

Changes or modifications not approved by JVC could void user's authority to operate the equipment.

Cassettes marked "S-VHS" and "VHS" can be used with this video cassette recorder. However, S-VHS recordings are possible only with cassettes marked "S-VHS".

By using S-VHS ET it is possible to record and play back with S-VHS picture quality on VHS cassettes with this VCR.

As an ENERGY STAR® Partner, JVC has determined that this product or product model meets the ENERGY STAR® guidelines for energy efficiency.

Page 1 Page 3
Image 2
Page 1 Page 3
Contents SR-TS1U Dear Customer Power Lines Power SourcesPower Cord Protection Grounding or PolarizationCleaning AccessoriesDamage Requiring Service Replacement PartsContents Connections Connect VCR to TV Installing/Removing the lithium batteryBack of VCR EN I Nitial Sett Ings Plug & Play SetupPlug & Play Auto Clock Set/Auto Tuner SetInformation Clock Select Host Channel Select D.S.T. ModeSET Auto Clock to on Semi-AutoSET Time Select Time ZoneReturn to Normal Screen SET DateSET Access Main Menu ScreenTuner Set Receivable ChannelsAdd Or Delete a Channel Access ManualChannel Or Shuttle Plus #Attach Controller Cable Box ControlSituate Controller Connect Cable BOX to VCRSelect Cable BOX Output Channel Access Cable BOX SET ScreenTurn on Cable BOX Set Cable Box Output Channel & Cable Box BrandBrand Code Access Cable BOX Brand SET ScreenEnter Cable BOX Brand DBS receiver DBS Receiver ControlConnect DBS Receiver to VCR Select DBS Receiver Access DBS Receiver SETTurn on DBS Receiver Output ChannelDBS Receiver Code from Following list, then Press OK Access DBS ReceiverSET DBS Receiver Brand JVC Dish Network Echostar Dish NetworkFind Program Start Point Simple PlaybackLoad a Cassette Start PlaybackSimple Recording Frame Playback Playback FeaturesActivate FRAME-BY Playback and Recording FEA Tures E NAdjust Manual Tracking Access Distant CodeEngage Manual Tracking Mode Activate HIGH-SPEED SearchSelect Picture Control SET ModePicture Control Shuttle Plus #to select Select Audio MonitorSelect The Soundtrack Shuttle Plus # to set to Video StabilizerActivate Video Stabilizer Review Instant ReViewReturning Position Or Shuttle PLUS%ÞRepeat Playback Counter ResetTape Position Indicator Next-Function MemorySuperimpose Audio mode Counter reading IndicationsOperation mode Tape speed indication Cassette Loaded markMovie Advance Press Skip SearchTo S Video OUT Video Cable Supplied To Remote To Audio Series PlaybackTo S Video OUT Video Cable Supplied Load Cassettes Make ConnectionsTurn on ALL Components Press Play on either of SR-TS1USeries Recording CamcorderPrepare for Recording SET Recording VCR’S Input ModeTurn on ALL Components Active Video Calibration Video CalibrationStart Playback PlaybackRecording Recording Features Or Shuttle Plus Record SafetySET Screen Shuttle Plus # to selectVHS Super VHS, S-VHS ET and VHS Access Function SET 1 ScreenSelect S-VHS Mode Super VHS ET Select S-VHS ET SETMode To Record SAP Programs Select 2ND Audio Record SET ModeStereo And SAP Second Audio Program Input Receiving Channel Number VCR Plus+ Timer ProgrammingTimer Recording Enter Pluscode NumberSP/EP ProgramInitial SET, then press VCR Plus+ SetupVCR Plus+ Guide Channel Matching Ex. When inputting the Guide Channel number 6 for WNJUInd Access Guide Channel SET ScreenEN Timer Recording Input Guide Channel NumberSET Program Date Express Timer ProgrammingAccess VCR PLUS+ SET Channel NumberEngage Timer Mode Check, Cancel And Revise Programs Cancel or Revise aRE-ENGAGE Timer ProgramAuto Timer Select Auto SP EP Timer SET ModeAuto SP→EP Timer SET Recording Duration Instant Timer Recording ITREngage ITR Mode Press REC on the front panelBefore performing the following steps Engage Auto Satellite Prog REC ModeAutomatic Sat- ellite Program Recording Select Edit for PIC Edit To Or From AnotherSET RECORDER’S Input Start PlayerEdit From a Camcorder PlayerSet your VCR to its record mode Select Rear AUX Input SET ModeSet the camcorder to its play mode SET TV Brand Code TV Multi-Brand Remote ControlTurn on the TV Operate TVOperate Cable BOX Cable Box Multi-Brand Remote ControlTurn on the Cable BOX Cable BOX Brand Name Brand CodeTurn on the DBS Receiver EN Special FeaturesDBS Receiver Multi-Brand Remote Control Enter DBS Receiver BrandPlug in Power Cord Unplug Vcrs PowerSET Remote Control Turn VCR Power onCassette gets stuck partway Make sure the cassettes window isProcedure Those in the previous area Timer againRe-perform the VCR Plus+ setup Doesn’t work properly Troubleshooting Other ProblemsCan the VCR indefinitely remain in the Record-Pause mode? Questions and Answer S E NCan the VCR indefinitely remain in the still mode? What happens if the tape runs out during recording?EN Index List Of TermsFront View Index Front Display PanelRemote Control Cassette Failure to heed the following precautions may resultDamage to the VCR, remote control or video Memo Memo Memo SR-TS1U
Top Page Image Contents