Press PROG. or OK. "PROGRAM COMPLETED" appears on the screen for about 5 seconds, then normal screen appears.
ENGAGE TIMER MODE
Press TIMER. The VCR turns off automatically and "ä" is displayed on the display panel.
7
8
Press SP/EP.
RETURN TO NORMAL SCREEN
6
PRESS (8=DAILY, 9=WEEKLY
STOP+/– = STOP TIME, SP/EP)
To change the stop time, PRESS (OK) TO END press STOP +/–.
To timer-record daily or weekly serials, press DAILY (NUMBER “8”) or WEEKLY (NUMBER “9”). “DAILY” or “WEEKLY” appears on the Program screen.
Pressing the button again makes each corresponding display disappear.
If you made a mistake, press CANCEL to access the VCR Plus+ screen again and input the correct PlusCode number.
If the PlusCode number you inputted is incorrect, "ERROR" may appear on the screen to advise you of the error. This happens when the PlusCode number is for a program which has already passed. "ERROR" is displayed for about 5 seconds and the VCR Plus+ screen reappears.
SET TAPE SPEED
12/24/99
THU
12 SP
8:00PM
DATE
= 10:00PM
CH
START
STOP
PROGRAM 1
(VCR PLUS+ 12345678)
The PlusCode number you entered and the matching Timer-Recording informa- tion is displayed on the Program screen. Check to make sure it’s accurate.
5
TIMER RECORDING (cont.)
CHECK PROGRAM DATA
SP/EP
ATTENTION
If there is a conflict in the timer schedule and one program overlaps with another, only the parts shown below in gray will be recorded.
Pattern 1: The program with the lower program number will be recorded.
10:00 | 11:00 | 12:00 |
Program 1 | | CH10 | | | | |
Program 2 | | | | | | | Not recorded |
| | CH40 | | | |
Pattern 2: The program that is broadcast earlier will be recorded.
10:00 | 11:00 | 12:00 |
Program 1 | | CH10 | | | | |
Program 2 | | | | Not recorded |
CH40 | | |
Pattern 3: The program that is broadcast earlier will be recorded, followed by the remaining portion of the other program.
10:00 | 11:00 | 12:00 |
Program 1 | | CH10 | | |
| | Program 2 | | |
| | | CH40 |
Not recorded
IMPORTANT
If you have moved to a different area or if a broadcasting station's channel number has been changed, the wrong VCR or CABLE CH number will be displayed on the VCR Plus+ program screen in step 5. When this happens, set the correct Guide Channel number for that station. ( pg. 45, "VCR Plus+ Setup")
NOTES:
To disengage the timer before recording starts, press TIMER again. Pressing once more re-engages it.
In case of a power failure after programming, the VCR’s memory backup keeps your selections (if the lithium battery is not exhausted).
When timer-recording cable channels received through a Cable Box, be sure to keep the Cable Box set to ON.
EN
