GoVideo GV2020 manual Priorities

Page 23

Setting the Timer to Record Later

If the timer is correctly programmed, PROG will be lighted on the Front Panel Display.

When the event begins recording, PROG and TIMER will be lighted.

If TIMER is flashing on the Front Panel Display, there is an error. The On- Screen Display will display TIMER RECORD ERROR, and DECK 1 (or DECK 2): TAPE MISSING or TAPE MISSING TAB. Check that there is a tape in the proper deck, and that the record safety tab is intact on the tape.

Your VCR-2 can be turned off once steps through are completed. TIMER and PROG will be lighted on the Front Panel Display. Your VCR-2 will automatically turn on when the event begins and will automatically turn off when the event is complete.

If you have a cable converter connected to the In From Cable connector on your VCR-2, as on page 35, you will need to make sure the converter is left ON and set to the proper channel for your Timer Recording.

Press Stop to stop an event that is in progress. The recording will stop and the timer settings will be cleared if the event was a Normal event. Daily and Weekly events will be updated automatically for the next date that was programmed.

If an event is not able to start properly, due to an error or because there is a tape playing in that deck, the event will be held. The On-Screen Display will display HOLDING EVENT and the event number, each minute until either the event is over or the problem is corrected. Any events that are held will stop at their original time.

An asterisk () next to an event number in the Timer Recording Summary indicates the event is currently recording or holding.

Priorities

With the ability to store settings for up to 16 events, your VCR-2 must prioritize the events. If two events require different channels, or the same deck at the same time, priority is given in the following order:

Latest starting time - An event in progress will be interrupted by an event with a later starting time.

Highest event number - If starting times are the same, event 2 has higher priority than event 1, event 3 has priority over 2 or 1, etc.

21

Image 23
Contents Video Cassette Recorder Model GV2020 Owner’s GuideDual-Deck WHO Provides the Limited WARRANTY? Limited WarrantySafety Instructions Clamps Contents Other Key Features of Your VCR-2 Features of Your Dual-Deck VCR-2Exclusive Features of Your VCR-2 Quick Connections Tape Front Panel Compartment Display Dual-Deck VCR-2 Front PanelCopy Tape Tape Dual-Deck VCR-2 Remote ControlDual-Deck VCR-2 Remote Control Programming Controls TV View Using Your Remote ControlPlaying Tape Record Safety TabDuplicating a Tape Playing a Tape While Recording from TV Recording from TVRecording Two Programs from TV ❶❷ ❸ Editing a Single TapeEditing Multiple Scenes Onto One Tape Stop One-Two RecordingSetting the Timer to Record Later ❺ ❺ Priorities Main Menu Programming from the Remote Control VCR-2 Front PanelOn-Screen Programming Main Menu ❶ ❸ ❹ On-Screen Programming Video Menu❶ ❸ ❹ On-Screen Programming Audio MenuOn-Screen Programming Set Date and Time On-Screen Programming Channel/Tuner Menu On-Screen Programming Channel/Tuner Menu On-Screen Display Front Panel Display Mono Stereo Timer Prog OTR Line Simul CatvAuto Features Tape Counter Memory Stop Combined VHF/UHF Antennas, VHF only, UHF only Antenna ConnectionsSeparate VHF and UHF antennas Cable Outlet Cable ConnectionCable Outlet Converter Cable Outlet Connecting Other Video Equipment Multichannel TV Sound MTS Stereo Audio Features ConnectionsSimulcast Monitor Connections VCR-2 Care of Your Dual-DeckRecording System Technical SpecificationsIRC Catv IndexSTD Catv Troubleshooting Copyright Warning