Magnavox ZC320MW8B/F7 owner manual Press REC to start recording, Press Stop C to stop recording

BASIC RECORDING & ONE-TOUCH TIMER RECORDING

6	Press [REC] to start recording.	Press [STOP C] to stop recording.
	“I” will be displayed for 4 seconds.
		The recorded title will appear in the title list.
		(Refer to “Guide to a Title List” on page 56.)
		7 e.g.) DVD+R

	I	SP(2Hr)	0h58m
				Please finalize the disc when the writing is
Press [PAUSE F] to pause recording.
				completed before playing back on other DVD
Press [PAUSE F] or [REC] again to restart				players.
recording.				Writing to Disc	90%

Introduction Connections Basic

To set one-touch timer recording (OTR)...

This is a simple way to set the recording time in blocks of 30 minutes.

Press [REC] repeatedly until the desired recording time (30 minutes to 6 hours) appears on the TV screen.

One-touch timer recording will start.

I0h30m

0h30m

(normal recording) 1h00m

6h00m 5h30m

To change the recording length during the one- touch timer recording:

Press [REC] repeatedly until the desired length appear.

To cancel the one-touch timer recording within the specified time:

Press [STOP C].

1	SP(2Hr)
NOV/20/11	11:00AM L1 SP
SUN NOV/20/11	0:20:44
2
EMPTY SPACE
1:41:17 SP(2Hr)

• Press [STOP C] to exit the title list.

Setup Recording Playback Editing Function

Note

•When you press [REC], recording starts immediately and continues until the disc is full or you stop recording.

•This unit cannot record images as aspect ratio of 16:9. The 16:9 images will be recorded as 4:3.

•When the unit clock has not been set, the space for a date and time of title names will be blank.

•You cannot change the recording mode during the recording pause mode.

•You can change a channel to be recorded during the recording pause mode.

Note for one-touch timer recording

•The remaining recording time will be displayed during one-touch timer recording. Press [DISPLAY] to see it on the TV screen.

•Unlike the timer recording, you can perform the following operations during one-touch timer recording.

-Turning the power to standby to stop one-touch timer recording.

-Using [REC] or [STOP C] on the remote control.

•You cannot use the pause function during one-touch timer recording.

•When one-touch timer recording is finished and the power is turned to standby, the unit will switch to the timer- standby mode automatically if a timer recording has been programmed. Press [STANDBY/ON y] to cancel the timer-standby mode to use the unit continuously.

Setup Others

Español

EN 27