Magnavox ZC320MW8B/F7 Satellite Link, Press OK again, To Standby Mode is highlighted

					SATELLITE LINK
7	Press [OK].
	“To Standby Mode” is highlighted.
8	Press [OK] again.
		Satellite Link
			Start	Mode
			5:00PM	SP (2Hr)

To Standby Mode

In a second, the unit will be turned off automatically as it goes into the satellite link standby mode.

To cancel the satellite link function while in the satellite link standby mode:

Press [STANDBY/ON y] to turn on the unit.

To cancel the satellite link function while the satellite link recording is in progress:

Press [CSTOP] on the front panel of the unit.

Notes

•If the signal of external input breaks up over 5 seconds, satellite link function will be canceled.

•If you have not set the clock, “Clock Setting” menu will appear at step 3. Follow to step 4 in “SETTING THE CLOCK” on page 23.

•You cannot set the end time for the satellite link timer recording on this unit.

•Recording picture will be distorted if the copy protection signal is being detected during satellite link timer recording.

•You can record the satellite link by using S-video input jacks on the rear panel. Refer to page 11 for more information.

•When a regular timer recording and the satellite link timer recording are overlapped, those recordings are recorded as illustrated below.

•Press [TIMER PROG.] during the satellite link timer recording to check the satellite link timer recording in progress.

	example 1		example 2		example 3
timer		timer		timer
recording		recording		recording
satellite link		satellite link		satellite link
actual		actual		actual
recording		recording		recording
The rst 2 minutes (at the longest) will be cut o￿.				The rst 2 minutes		(at the longest)	will be cut o￿.

Introduction Connections Basic Setup Recording Playback Editing Function Setup Others

Español

EN 33