Magnavox ZC320MW8B/F7 Use K / L to select the appropriate, External input position L1/L2 to, Mode

					TIMER RECORDING
	Use [K / L] to select the appropriate					7	Press [OK] when all items are entered.
	external input position (L1/L2) to						After displaying an instructive message for 10
5 which your external tuner is							seconds, timer program list will appear.
	connected, then press [B].						Press STANDBY-ON to Timer standby mode.
							Ensure the external source is turned to
							the correct channel.
	Date	Start		End
	JAN/07	12 : 00AM 1 : 00AM
	L1/L2	Mode
	L1	SP
		SP		1h00m			Timer Programming
6							JAN/ 7/11 12:00 AM L1 SP
							SP (1:00)		THU JAN/06 11:00AM
	Use [K / L] to select a recording						Date	Start	End	L1/L2
							JAN/07	12:00AM	1:00AM	L1
	mode.						Your program setting is now stored.
							• To set another program, repeat steps 2 to 7.
	Date	Start	End				• To exit, press [TIMER PROG.] or [MENU].
	JAN/07	12 : 00AM 1 : 00AM					• When 2 or more programs are overlapped,
	L1/L2	Mode
	L1	SP					“Timer program overlapped” appears, and the
		SP		1h00m			overlapped program will be displayed in blue.
	Refer to “Recording Mode” on page 24.						• To correct the timer program refer to
							“Checking, canceling, or correcting the timer
	• You can check the remaining recordable space
							programming information” on page 30.
	of the disc when you select the recording mode.
	Date	Start	End				Press [STANDBY/ON				] to set the
	JAN/07	12 : 00AM 1 : 00AM
	L1/L2	Mode					timer program.
	L1	SP
		SP		1h00m			TIMER REC indicator will light up on the front
Auto recording mode select...						8 panel.
When “Auto” is selected as a recording mode, the unit
calculates how much time is available on the disc and
selects the best recording mode available
automatically to complete recording the program.
	Date	Start		End
	JAN/02	12 : 00AM 1 : 00AM
	L1/L2	Mode
	L1	Auto		Auto	1h00m

•“Auto” is only available for one program in the timer program list.

•The recording may be cut short when the available recording space of the disc is too limited.

Introduction Connections Basic Setup Recording Playback Editing Function Setup Others

Note

•If you have not set the clock yet:

Entry screen for the clock setting will appear instead of the timer programming list at step 1. Continue with the step 4 in “SETTING THE CLOCK” on page 23 before setting a timer programming.

•Use [s / B] to move the cursor to the left and the right in the entry screen for the timer programming.

•You cannot make a program whose recording time exceeds 12 hours.

Español

EN 29