Swann SW244-8ML manual Rear Panel 8 Chan

REAR PANEL (8 CHAN-

10ALARM IN & OUT

7POWER CONNECTION & POWER SWITCH

5 RS-485

CAMERA × 8

1CAMERA CONNECTION

2 AUDIO/MIC 9 VIIDEO OUT

RESET

6RS-232

8 USB MOUSE 3 VGA MONITOR 4 NETWORK

1

2

3

4

5

6

7

8

9

Camera Connection

Connect the CCD cameras to VIDEO IN on the rear panel of the DVR.

Audio connection

Connect a microphone to AUDIO IN 1 & 2 and speaker to AUDIO OUT on the rear panel of DVR. Audio input and output should be amplified, since the DVR does not have an embedded amplifier.

VGA Monitor Connection

Connect the VGA monitor to the VGA on the rear panel of the DVR.

Network Connection

Connect the Normal LAN cable, connected to the network, to the network RJ-45 connector on the rear panel of the DVR.

RS-485 Connection

Connect the cable to RS-485connector on the rear panel of the DVR.

RS-232 Connection

Connect the cable to RS-232connector on the rear panel of the DVR.

Power Connection & Power Switch

Connect the power cord to the MAIN POWER connector on the rear panel of the DVR. The DVR is booted up when Power Switch turns on.

USB Connection

Connect the USB mouse or USB storage to the USB port on the rear panel of the DVR.

TV Monitor Connection

If you want to use a TV monitor, connect the TV cable to VIDEO OUT on the rear panel of the DVR. But you may not see almost OSD on TV monitor.

10Alarm In & Alarm Out

Connect the sensor and alarm to the Alarm In & OUT on the rear panel of the DVR.

11Reset (ID & PW reset)

RESET button is only used to restore ID & PW to factory defaults. To initialize DVR’s ID & PW, press the RESET button with a straight clip for about 3 seconds.When it is reset completely, the ID & PW reset message will displayed on the screen.

5